Bafang M560

[Sayonara]

Why would it be different? It works fine with M600 motor and ultimately pushing same amps as it requires.

Same reason any manufacturer makes choices that doesn't benefit the consumer. Money. Planned obsolescence. There could be something in the controller or in the battery BMS. Many brands have used these tactics since the start of their products.

 

[Dado]

Haha for those eternal 30 seconds, I was able to ride it and it does seems to be very quite and has good amount of power... Drill is to reach for power button every 30 seconds

I tried different display as well but nothing worked. Going to update firmware today to see if that fixes the issue.

Bafang have not learned from M510 past. FC2.0 was 4th revision...
Let us know if firmware upgrade worked. Lets see if controller still communicating.

And you almost been waiting for these 30 seconds of thrilling ride only after the bolt delivery ....

 

[Dado]

Same reason any manufacturer makes choices that doesn't benefit the consumer. Money. Planned obsolescence. There could be something in the controller or in the battery BMS. Many brands have used these tactics since the start of their products.

That is right. They dont listen to consumer needs, but listening to 2 words: "cost savings".

In this case it is working also with battery without CAN info (unless u have a special motor firmware). M625 was a black swan - worked only with Bafang Can BMS.
Then on later M635 you can again plug any DYI battery without CAN.

 

[rfarsocal]

And you almost been waiting for these 30 seconds of thrilling ride only after the bolt delivery ....

 

[rfarsocal]

Keep getting "The SN of controller should start with 'CR'" when trying to update firmware on M560.

Anyone here encountered similar problems?

 

[Dado]

Go over Besst Pro.

 

[rfarsocal]

Go over Besst Pro.

Tried that as well, It loads firmware to BESST tool and then when i unplug and plug back connection to let it update firmware to motor nothing happens.... no double beep at all.