Search results

I hammered them with a rubber mallet. 😉

Much appreciated. :)

Can anyone confirm that these two pieces should be pressed into the frame?

But I think a little grease is useful in preventing the entry of water and moisture. There are different opinions about this. 🙃

I think all these parts are movable and therefore need grease?

I will only apply grease to the internal parts that are likely to be subjected to friction.

I have inner washers on each side.

Thank you, I also noticed that the screws were not tightened to the maximum torque. For example, a screw with a maximum torque of 8 Nm is tightened at 5 Nm. Should I tighten the screws to the maximum torque or a little lower to preserve the carbon frame?

I discovered that there is no grease in the screws areas, should grease be applied to these areas or is this intended because the frame is carbon?

Nice color (y) I don't have any experience with painting, I haven't tried that before. So I will try to accept the frame with the unique waves :) The important thing is that it is flawless. Thank you for trying to console me I'm much better now. 😃

Yes, you are absolutely right. Maybe it's my fault, I had a different perception I didn't know glossy carbon would look like this. But this is a half-truth. When I asked Dengfu what the glossy carbon frame looked like, they sent me this photo, which does not match the frame that was sent to me:

This is Dengfu's response: It is not bad painting, but UD carbon weave. UD glossy is just like this. I find this frame so unacceptable, it looks distorted.

In some sides the lacquer is perfect, in others it is inhomogeneous.

When ordering there were two options glossy or matte I choosed glossy.

The frame is painted very badly, is this normal or just the frame they sent me?

My frame has arrived today, but without a battery. Dose it usually arrive separately or with the frame?

Yes, my fork is compatible with a 220mm disc size. Is it the same Adapter for the rear wheel?

I can't find a Magura MDR-P 203mm disc brake they are sold out so I will probably have to buy a 220mm for both wheels. What are the compatible adapters in this case? PM 180-220mm? https://www.hibike.de/magura-quick-mount-adapter-p5a382849400d279eadcedc982aa432bb#var_62119129

Thank you @thaeber , I think you are using Magura brakes. I would also like to install Magura MT5e brakes with MDR-P 203mm disc on both wheels. What adapters do I need in this case? My fork will be rockshox lyrik ultimate 27.5" 160mm.

What size clamp do I need for a 31.6 seatpost?