I will share with you my opinion about the new Bafang engine M510
In fact, I wasn't expecting this huge improvement in performance, power and energy savings, especially since my experience with the M500 engine was not satisfying in some points, but the new engine is so powerful that I can climb...
I finally finished building my e-bike. The fun while building is indescribable especially since there is room to get creative in customizing the bike.
It wasn't easy and so far I still have some open questions but maybe with time I'll figure it out myself.
A big thank you to everyone who helped...
The tool is compatible with this lock ring from Bosch, but can we use this ring to tighten the chainring with Bafang M510 motor?
I'm looking for a solution because I don't have an extra old lock ring.
This is cheaper than the old Bafang lock ring and more available for sale.
My tire size is 27.5" x 2.6"
Circumference: 2243 mm
When entering this data, nothing changes on the bike display. It appears again that the wheels size are 27".
Even if I change the tire circumference to any other number, nothing will change.
When I choose 27.5" wheel size using BESST, it appears 27" on the bike display, what is the reason?
Or should I choose the wheel size 28?
My bike wheels are 27.5" front and rear
Hi @Kiwin I am in the final stages of building my ebike and need a little help.
What torque should I use to tighten the three engine mounting bolts?
According to the engine installation manual, the three screws must be tightened with 35 NM Isn't that too much for the carbon frame?
Today my motor arrived but on the sticker is written that the maximum speed limit of 32km/h instead of 25km/h.
This is annoying if the police in Germnay check the motor.
Do your motors have the same sticker with the same maximum speed?
As I understood, is the new Firmware just to get the same performance as much as possible when the battery voltage drops? Without power saving mode at a certain percentage?