How to Tune a Bafang M560 Using BESST Pro to Match Bosch CX Gen 5 or DJI Avinox Performance?

[guga06]

Apologies if this has been asked before, but I searched the forum and couldn’t find a satisfactory answer.

I'm looking to adjust the settings of a Bafang M560 motor using BESST Pro to make its performance as close as possible to a Bosch Performance Line CX Gen 5 or the DJI Avinox Drive System.

Specifically, I’d like to optimize:

• Torque settings: Bosch delivers 85 Nm, while DJI offers 105 Nm (120 Nm in Boost mode). What would be the best torque setting for the M560 to replicate their power delivery?
• Assistance levels: Bosch provides up to 340% support—how should I configure the M560’s assistance % per level?
• Power curve & cadence response: Bosch supports up to 120 rpm cadence. How can I fine-tune the power delivery so that the M560 provides smooth and natural assistance at higher cadences?
• Startup behavior: Both Bosch and DJI have very refined, responsive power engagement.
  How can I tweak the Startup Angle, Acceleration, and PAS Curves to get a similarly smooth start and acceleration?
• Max power at a given torque: How can I configure the system to deliver peak power at a specific torque value, similar to how Bosch and DJI modulate assistance?

Has anyone experimented with these settings?
Any insights on achieving natural and responsive pedal-assist performance similar to Bosch or DJI?

Many thanks in advance!

All the best,
Gus !