Search results

Hello James, dont worry, I am declaring low value. So you wont be paying anything extra. Already shipped a lot of devices to UK. To UK expect 5 to 8 working days to deliver.

Yes, it was same person, he went his favourite trail. That difference you see in time is also a difference in average motor power on the track. Some guy from USA did shared this on FB group.

Guys this is real comparison between M510 Fc2.0 and Bosch. Difference is huge. We are all out of topic here with M510.

30A was 1000W version. No more. What is funny, now it has 19A. M600 has 20A. How hard is to update M600 with new controller and switch to magnesium body?

Sayonara, you are right with "race" mode behaviour. Like a Bosch. Just also turning more to side that bafang does not know what is doing and this "feature" is actually a bug. :)) With some firmwares it even get worse (takes longer) with low battery SOC.

Been riding M820 for few tens of minutes and did not have feeling, there is problem with higher caddence. Automatically as I am hitting some caddence I am naturally pressing shalter. But yes, this can be easily fixed with higher gear ratio inside (but acceleration could suffer a little).

That is right, M510 and M560 has some power adjustments. Also one firmware for M620.

Only one u will be able to load into your controller. And no, M600 does not have any possibility to tune. Just to set speed limit, wheel size and circumference.

Hello. You can upload 48V firmware but then of course would show wrong SOC as you writing with 43V battery. Go with 43V firmware. You wont get anything with 48V firmware and 43V battery, just less power (as 48V firmware has less max. power) Put there attached 43V firmware. One is for oldM600...

Ok, so then controller is dead. It is not communicating with Besst. :(

Go over Besst Pro.

That is right. They dont listen to consumer needs, but listening to 2 words: "cost savings". In this case it is working also with battery without CAN info (unless u have a special motor firmware). M625 was a black swan - worked only with Bafang Can BMS. Then on later M635 you can again plug...

Bafang have not learned from M510 past. FC2.0 was 4th revision... ;) Let us know if firmware upgrade worked. Lets see if controller still communicating. And you almost been waiting for these 30 seconds of thrilling ride only after the bolt delivery .... ;)

Right, u made it total silent now. ;)) Dont know what is driver panel....

30 seconds is new record. ;))

Hello. That left and right bolts does not play a big role. You can ride without. Just hit peddals with a hammer :) and tighten 4 bolts.

Hello Peter. Where did you get this byte position and are you sure this will change max motor current? It is not so easy. ;)) You can try, dont worry about CRC, you will get just error message that CRC does not match, but Besst anyway allow to flash your modified firmware bin file. Possible to...

I am affraid will be silent only with nylon gear. They can do M600 silent (even more then M510), so where is problem. I would say 22A that nylon could handle. But is funny how they stating it is silent, and actually is not.

That is normal, you can not see under BT devices. It depends what BT protocol is display using. There is lot of protocols on BT.

Comments mean what It says. ;) 46.4 is for new controller. Throttle with old controllers worked according PAS. New controllers, If I remember right, Bafang did changed and throttle is working still on full power. Other parameters you asking - just try if suit you. Or go through the forum for...