Search results

No, there should not be any "bump". Do u have the screws of pedal tighten? Seems unscrewed, then it can bump into stator part.

No one brought this as nobody has problems with bend cables under the plastic cover. ;) You are the first. I have there enough space, would you like a picture? Problem are the connectors usually - does not have contact, when not plugged till the end. And water is going in, then a pin with full...

Some news. Will start working on slightly smaller BBR. ;) Unlucky, still will be a problem to hide just under left plastic cover. Seems there is plenty of room under the cover, but was surprised is not. Also can fake speedsensor, which could open ASLS function on M510 FC2.0 and M560. Automatic...

Thanks @Kyokushin ! Also riding BBR on my bike, now still looking to real time motor temperature at service mode 3. ;) One would be surprised how quick M600 is going into high temperature. These hot days, temp is raising over limit even at PAS 4. Did set limit to 115C.

Ah ok, thanks for answer. That is sad they stopped making new soft. :(

Hello Neeko. Dont u have some new M420 firmware to share? I have only some very old one. Thx.

It is strange and they pretend they dont hear it. It sounds in hight RPMs same as when you step on cats tail. ;) At least they could put nylon into 500W version.

Good news. Firmware v1.5 has unlimited throttle. Or better say, now works as used to. If I set speed limit 25kmh also throttle is limiting at 25kmh. Edit: So it has tricked me again on the bench. Does not work over 45kmh, only rotating chainring with low power. But is interesting why they did...

And never will be programable. :( I guess M600 wont have any updates in future.

Think about switching to M560. Much better for setup, also better torque sensor behaviour. Only that noise... :(

Hello. Unfortunately no, M600 is supporting only basic parameters: Speed limit, Wheel size and Circumference. There is one firmware v46.2 for new M600 where is possible to set also power levels. But this firmware is giving first 2 seconds after start pedaling 500W kick. It all depends how it...

Hello Neeko. Have a note at this firmware it has lowered power at low PAS: 3,6,12,20,30A Attaching version 1.2, little newer, if somebody wants to try. Is great as supports also power setting.

To sensor with 4pin connector you need a reduction. 4 pin to 8 pin cable. You have more complicated case as I found out from your email description. ;)

Hello. Is possible possible, just to flash 48V firmware. Check simple device K1 Flash, comes also with firmwares.

Startup angle does not affect performance or battery. It is just how much you need to rotate cranks to start motor assist. In GO+ is still missing Assistance level parameter, which is important.

Hello. Will buy Sonni frame. No need motor. Thx

Hello. Will buy Sonni frame. No need motor.

I have android and personalized ride works. You need to have HMI fw 1.2 Firmware versions to check is on the display under Info - simple. To go to menu hold plus and minus, or double tap "i" button. Controller firmware update, rotor calibration and to set all the parameters without any...

Speed limit, Wheel size and circumference is not possible to set over Go+. Version of HMI is under Info. And what you mean by flashing to 48V battery? You can update controller firmware to any voltage, but you wont see any difference in Go+.

Hello DPC245, right? Must be hw v3 and fw. v1.2 Assistance % still missing in new Go+ :(