What did you buy your ebike this week?

[Polar]

That’s a good one!
Mine has been a while now, like it a lot.

Thanks mounted it today but have to adjust the bar a bit the next days to find my sweet spot angle

 

[Polar]

Does the bar have the crease in it to allow for the wires to run under the grip? If not what did you do instead?

I just took of the old original bar and mounted the new just like the original one no problem with wires

 

[UnreasonableMuppet]

My bike was nicked last month, so just splurted out on a new Haibike Lyke CF11, some Exposure lights from their outlet store, some pedals and a fox mudguard for the 36's.

Here's a generic pic to muster opinion...

View attachment 121169

I have an opinion about this one.

I think it's a sick bike, and I'm completely butt hurt that it's not sold in the USA. I want one too.

I'd get the 10, just because that's my favorite color scheme.

 

[jimbob]

Nothing top exciting. Just new pawls for the freehub as after I last stripped it down one of then just seemed a little too slow for my liking.

 

[Nomad1]

View attachment 121536

Nothing top exciting. Just new pawls for the freehub as after I last stripped it down one of then just seemed a little too slow for my liking.

I'd go with a ratch system but, that does cost more money and you may feel it's not worth it or simple not feel the need to

 

[jimbob]

I'd go with a ratch system but, that does cost more money and you may feel it's not worth it or simple not feel the need to

I've been thinking of doing just this, but went with this as a quick option (and only £10) while I look into converting.

That said, when I looked into it in the past, I couldn't see all that many upsides to a ratchet system?

 

[Nomad1]

I've been thinking of doing just this, but went with this as a quick option (and only £10) while I look into converting.

That said, when I looked into it in the past, I couldn't see all that many upsides to a ratchet system?

I can tell you simple put it just works better

 

[militantmandy]

An EDC Lite and a waterproof onesie!

 

[Doomanic]

Getting ready for "summer"?

 

[militantmandy]

Getting ready for "summer"?

Exactly! It's rained almost every day since I got the new bike

 

[Geedog]

Hello, i recently treated my bike to a set of zeb ultimates, an excellent fork, with best damping that i have had.

 

[Sparkydave]

Just ordered a one-up dropper, some orange Hope bits, a 29" Fortus 30 front wheel and some 180mm Fox Factory 38's to mullet my 2019 Kenevo. PFA - will post pics when fitted

 

[Defmech]

AXS Rocker Paddle; fitted but not used yet.

 

[Mcharza]

The former bull's neck, the current chicken neck, needed a new, lighter helmet
TLD Stage, I found this for a good price on the interwebs

 

[Mamba90]

Some 155mm cranks for my Wyte e160. Inserts to match my garish Hope headset.

 

[Kimmoi]

GX AXS kit for my Levo.
Because i "almost had to": new cable housing assembly apparently is impossible to do without dropping motor down.
No way to put new housing in place. Two hours i tried.

So i ride singlespeed until AXS arrives.

 

[JStrube]

I can't believe nobody bought anything over the weekend!

 

[Geedog]

Hello again. This week i have new xt spd

pedals and a new lighter spring for my rear shock, i went for the cane creek spring as it was a bit cheaper.

 

[Christurbo]

GX AXS kit for my Levo.
Because i "almost had to": new cable housing assembly apparently is impossible to do without dropping motor down.
No way to put new housing in place. Two hours i tried.

So i ride singlespeed until AXS arrives.

Cable housing is dead easy to push though on a Gen3. However nice upgrade

 

[Kimmoi]

Cable housing is dead easy to push though on a Gen3. However nice upgrade

Apparently i had just bad luck; i've heard that is easy on a Gen2 also.

But on my Levo it was pretty tight to pull old one out. At that moment when i pulled it out i knew i was in deep troubles.

New cable housing was just impossible to push thru. Maybe there's somekind of dent or something on that nylon tube which runs above motor.

 

[Matt van]

Most of my parts have arrived so I can start the Kenevo build. Just need the larger chainring.

View attachment 120822 View attachment 120823

winner right here

 

[Matt van]

just a plain set of tubeless tyres

 

[Polar]

M wave plus floor stand

 

[VWsurfbum]

I can't believe nobody bought anything over the weekend!

I didnt buy anything for a bike, i bought a bike.

 

[RustyMTB]

I didnt buy anything for a bike, i bought a bike.

Now look here young man. You've been around long enough to know you can't just leave it at that.

 

[VWsurfbum]

Now look here young man. You've been around long enough to know you can't just leave it at that.

Well in truth what I've bought is a build slot.

A build slot for a Orbea Wild M-Team Custom 2024 build, custom colour and a few spec changes.
Once i get the rough delivery date I'll start with the wheel build and see what additional Bling to purchase. I must admit I forgot I had AXS on the Heckler, and apparently I'll miss that, I'm not so sure?

 

[JWDubois]

Oury locking grips, a tubeless tire repair kit, a 12 speed master link, some 20g CO2 cartridges, and a floor stand.

 

[irie]

Pedaling Innovations Catalyst One pedals (black), bought from US web site and saved 25% (maybe got lucky because no duty/VAT charged). Huge platform, now tuned with less (10 each side instead of 18) but longer pins (supplied with pedals). Take a bit of getting used to but absolutely game changers, especially downhill! Can keep feet flat instead of effectively standing on tiptoe IYSWIM. Also dropped seat 25mm so lowered CoG when seated.

 

[Miket775]

New set of 40mm rise fatbar lites to raise the front up a little

 

[steve_sordy]

Does it count oi it was a gift?

If so, this is what my elder daughter bought me. I've always wanted one, but could never justify one as I wouldn't use it very often. Zoom in to see all the bearing sizes it will do.