I'm getting ready to upgrade my M510 from fc1 to fc 2.1, while in there i'm replacing the torque sensor too. Do you know if i can do both at the same time, or upgrade the controller first, calibrate it, then replace the torque sensor and calibrate it?Thats a good decision. M510 has also power adjustment support. Also with Assistance level %.
I see just a little change on controller board FC2.1 - few components are different or missing. So I guess some minor controller update.
Thats a good decision. M510 has also power adjustment support. Also with Assistance level %.
I see just a little change on controller board FC2.1 - few components are different or missing. So I guess some minor controller update.
Rotor | 15*32*8 16002 2Z 9*26*8 629 2RS |
3rd Gear ("Peek") | 12*28*7 16001 2RS 8*24*8 628 2RS |
2nd Gear (Middle) | 12*28*7 16001 2RS 15*32*8 16002 2RS 14*20*26 HFL1426 One Way Bearing |
1st Gear (Outer) | 50*65*7 61810 2RS 50*65*7 61810 2RS 48*54*3 Oilseal 36*43*22 One Way Bearing |
Torque sensor | 22*28*12 NK22/12 22*28*4 Oilseal 22*42*10 60/22-10 2RS |
I disassembled my motor, I can confirm the bearing is an odd size, and doesn’t seem available my bearing needs changing somehow its rustyHello, has anyone ever changed the motor bearings?
This is the list I found online, I have doubts about the torque sensor bearing, 22*42*10 60/22-10RS, it is not available on the market, has anyone disassembled it?
Rotor 15*32*8 16002 2Z
9*26*8 629 RS3rd Gear ("Peek") 12*28*7 16001 2RS
8*24*8 628 2RS2nd Gear (Middle) 12*28*7 16001 2RS
15*32*8 16002 2RS
14*20*26 HFL1426 One Way Bearing1st Gear (Outer) 50*65*7 61810 2RS
50*65*7 61810 2RS
48*54*3 Oilseal
36*43*22 One Way BearingTorque sensor 22*28*12 NK22/12
22*28*4 Oilseal
22*42*10 60/22-10 2RS
Is there no marking on the bearing?I disassembled my motor, I can confirm the bearing is an odd size, and doesn’t seem available my bearing needs changing somehow its rusty
The World's largest electric mountain bike community.