Bosch Gen4 gets more power, is faster than Turbo Levo in drag race
- Thread starter Rob Rides EMTB
- Start date
I didn’t think it was available yet?
I don't think it is, had mine done yesterday, doesn't feel any different, even though I was told it was the new software.
PhilBaker
Well-known member
Maybe your dealer gave you 1.0.3 (you can check on your display).
if the new version isn’t out yet hat perhaps was the latest the dealer had...
if the new version isn’t out yet hat perhaps was the latest the dealer had...
The review on Ebike-Mtb says its not that noticeable for most riding
Exclusive test: Bosch Performance Line CX 2020 software update with an extra 10 Nm
There’s a new, free software update which gives the Bosch Performance Line CX an extra 10 Nm torque. We’ve already tested it for you and compared it against the old firmware.
ebike-mtb.com
"If you’re hoping to use the update to make your current motor a lot stronger, you’ll be disappointed. While the update increases the torque of the Bosch Performance Line CX by 10 Nm, in most riding scenarios you won’t even notice the difference, because both the maximum support of 340% and the peak power output remain unchanged. On the trail, you won’t notice the additional torque even when riding in the Turbo mode at higher cadences, because the motor reaches its maximum power at a lower torque. You’ll only notice the difference between the “old” and “new” software when pedalling at lower cadences, approximately below 70 rpm. On the trail this offers real advantages, especially on short climbs and when accelerating out of corners. Here the updated motor accelerates more willingly and responds more dynamically, even if you’re riding in the wrong gear at a low cadence."
- Thread starter
- #37
I disagree with that Ebike article.
We (@TheBikePilot and Adam) instantly noticed a difference, not necessarily in the max output, but the on the initial pedal strokes from a stand still. It’s like night and day compared to the original.
And to be honest most riding on trails is from low speed / stopped to moving rather than flat out max pace it’s likely that most users will notice a big difference in everyday riding.
We (@TheBikePilot and Adam) instantly noticed a difference, not necessarily in the max output, but the on the initial pedal strokes from a stand still. It’s like night and day compared to the original.
And to be honest most riding on trails is from low speed / stopped to moving rather than flat out max pace it’s likely that most users will notice a big difference in everyday riding.
BigLee
Well-known member
I've seen on another online review that the update is available from July 20th, only 1 specifying a date tho
Akiwi
🐸 Kermit Elite 🐸
Unfortunately all Bosch motor updates have to be done at the local LBS.
Wow there are some pretty cool Kiox upgrades too.
You will be able to do navigation with the Kiox. It needs to be connected to your phone. I can see this as being great news when navigating when it is pissing down with rain (Otherwise I have my phone on my stem).
Also it will be possible to create your own screen layouts.
Software update this summer sometime.
Kiox: The eBike display for sporty eBikers
These displays can be intuitively controlled via the control unit, they're compact and protected from splash water and dust – the ideal sporting companion.
www.bosch-ebike.com
Last edited:
It was night and day so I'm not sure that the update you got was the latest. I believe the one most LBS have at the moment prevents you from getting spurious 504 errors. You'd know at the first crank if you had the new update
It felt like I was riding an eMotoX and put the same smile on my face like the first time I rode and eBike.
Last edited:
That's the latest update but not the 85nm one
Is update available now? My shop won't update the bike whilst they build it any day now
Steve940
Active member
No...end of July
Jared74cornwall
Member
Book it in soon as then as the update isnt out until end of july it can only be done by bosch dealer
Moe Ped
Well-known member
I thought the same thing too, as it’s already being tested why is it being held back till the end of July.
Why?
You think this a ploy by Bosch to destroy every gen 4 motor, so they have to replace them?
As I have stated two of us had our Trek rail software updated to the latest a couple of days ago.
We have both had the bikes since January and they have been error free.
Today after about 10 miles my friends one come up with a 510 error.
It couldn't be reset at the trail so went to dealer but they couldn't fix it either.
Now got to wait for Bosch to get back to us.
We have both had the bikes since January and they have been error free.
Today after about 10 miles my friends one come up with a 510 error.
It couldn't be reset at the trail so went to dealer but they couldn't fix it either.
Now got to wait for Bosch to get back to us.
Ah Jesus no way.. ?
Doug Stampfer
Well-known member
Yes that may turn out to be a problem in a while as the downhill tracks will become attractive to bloody ebikers wanting to ride up them. I can imagine the howls of outrage as $20 000 worth of gear become mangled together.
I most of the reviews of the software update they talk of the increase of horsepower means less chain shifts & less wear. That doen't make sense to me, I thought the extra torque would be more of a strain than shifting with power eased off.
Tony.OK
Active member
My Trance that I've just sold had all the torque down low and did 2000km on a chain and cassette, definitely less gear changing on climbs compared to mate on bosch bike, shifting under power def hurts components more than a bit more torque on its own. In my head I'm happy to have slightly more maintenance on drive train for the fun factor the ebike give me tho haha.
I have Orbea Wild FS H30 with Bosch and Giant Reign E+1 with Yamaha. I just updated the Yamaha through the app! So easy. I wish Bosch let us user update it through an app. No need for LBS visit. The Yamaha increased their max support from 340% to 360%. Also all the 5 level is customizable. Motor wise I’m loving the Yamaha. I’m also slightly faster in the Giant before the update. The Giant instill more confidence to me.
Doug Stampfer
Well-known member
Yes I rarely use Turbo & unless on a smooth long uphill I find the way Turbo kicks in & out to be a pain in the arse.
Well that's very disappointing.
Similar threads
EMTB Forums
Latest articles
-
The most reliable motor brand (in Norway)
A poll was posted on a big Norwegian emtb facebook group. There are...- Knut Nes
- 3 min read
- Views: 2K
- Reaction score: 5
- Comments: 15
-
2025 Canyon Spectral:ONfly CF Ltd review
We were quite surprised to read about the new lightweight Canyon...- Knut Nes
- 7 min read
- Views: 1K
- Comments: 1