michael.kozera
New Dad ! 👶
hi all, just another crazy build from your truly.
it was a 27.5, but i re-welded the rear swing arm longer to fit 29er, and larger fork for 29er also.
stock travel was 165mm, increased to 195mm after lengthening the swing arm cuz math's.
front fork is 200mm,
200mm rotors front/ rear.
1500w controller x 2
I 3D printed a 126x 18650 holder that fits inside the frame.
using LG-mj1 (3500mah) so 126x 1600wh battery 52v (14s)
front motor is controlled via thumb throttle only, rear wheel is PAS/different thumb throttle
havent finished yet, but took it out for a test rip, around 70km/hr top speed. motors are gears for Torque and o boy does it pull hard.
it was a 27.5, but i re-welded the rear swing arm longer to fit 29er, and larger fork for 29er also.
stock travel was 165mm, increased to 195mm after lengthening the swing arm cuz math's.
front fork is 200mm,
200mm rotors front/ rear.
1500w controller x 2
I 3D printed a 126x 18650 holder that fits inside the frame.
using LG-mj1 (3500mah) so 126x 1600wh battery 52v (14s)
front motor is controlled via thumb throttle only, rear wheel is PAS/different thumb throttle
havent finished yet, but took it out for a test rip, around 70km/hr top speed. motors are gears for Torque and o boy does it pull hard.