Search results

I've now got the dreaded drive side creaking and some bb play. Suspect it's back to Wiggle. Anyone tried to phone any Shimano service centers to see if they'll do the motors? Never buying another direct to consumer bike again that's for sure. I'll be getting a Kenevo next at this rate just...

Anyone else able to check how close theirs is? This is the gap with the other wheel installed. It's still bloody close but does clear.

Cheers both, Rotor is straight and mounted correct way around. It's been fine for ages but I do take the wheel in and out quite often and do remove the cassette at times to give it a good clean but I can't see the cassette side being related as its the rotor side that's touching. I borrowed a...

Hi all, Anyone seen this before. Boost pro 4 hub (148) all stock and the disc is just touching the caliper mount. It's bloody odd. I remove the wheel quite often and this just started today. Checked the hope spacers are installed. Reseated the cassette no change. Disc is straight and...

Mines not got a panel without a scratch ? although I don't care. It's a bike as long as it's mechanically maintained paint can look rubbish.

I've just purchased a Di2. I already have your app and it works perfectly. Will this update be enough to change the motor to work with the Di2 or are further changes required?

I'm based in the Forest of Dean. Welcome to try my large. Standard rule applies. You break it you buy it :D Oh and you'll have to tow me and my swoop up the hills ;)

I know there is nothing special about them. I have two other wheel sets using pro 4 hubs. I just know what they wear like and have spares, freehubs etc already. Wasn't sure how they'd deal with the eBike though.

Cheers all. Its not the rear mech, I've checked it, as the original symptom mid trail, as guessed above, was shifting issues so went there first before the axle. I'll check frame bearings too as I haven't done that yet. Was hesitant to add lock tight but some blue might not hurt at least if...

Anyone else had issues with their thru axle coming loose? I've tried correct torque settings and over torquing a little but 2-3 trails later and it's loose again. Getting frustrating. The first time it could have been nasty. I've got a feeling my rear wheel bearing might be at fault, there...

?. Should have checked latest posts before posting ?

Blast from the past but just seen a coil on the 2019 bike so it can fit ?

Here's a slightly longer clip edit from Sunday.

A short clip video on my Instagram. Can't seem to upload it here.

Everything I had on that said waterproof isn't, I can give you a list of what not to buy :LOL:

I'm after his title then. I stopped counting at 4 :ROFLMAO:

I won't lie, it was wet. Not a bit wet, proper wet but it wasn't cold. The rain didn't dampen spirits though, still an amazing ride around some of the lesser known trails. Thanks to the EMTB Forums team for arranging and @fodmtb for showing everyone around. Great day on the bike. I'll...

@Doomanic I tend to ride the stuff that fodmtb rides so I'm not actually that familiar with the blue trails around pedal a bike away. I'd probably lead the group down something outside of their comfort zone :ROFLMAO: Happy to discuss on the day and see what works and the groups comfort leve...

As this is 2 miles from me it'd be rude not to. Be good to ride with fodmtb. Happy to be the tail rider as I know the area.

Anyone else got an always on pear tune. Looking at it my cable should have two female connections, one for power and one to plug into the motor. Then one male to take a feed from the sensor. Mine seems to have two males and one female. Anyone got one to compare or am I being stupid(quite...