Maybe one of the brass slider pins has moved and caused an issue. Just describing what happened to my dropper, not saying this is what happened to this dropper. But if they can get away with it they will.
Now this maybe a coincidence but I had a standard reverb not the AXS, and this had a scratch down the back side of the shaft and it was notchy when depressed. I sent it off for repair and it was a bent shaft. So according to the guys at TF tuned the shaft and internals aren’t to dissimilar to a...
As my ocd kicks in with my drive train is it’s dirty, I tend to take the chain off and soak it soapy warm water for 10 mins to get the big chunks of turd off the chain, then I dry it with a rag. Next I spray it with WD and leave to soak for a while. I’ve even been known to get a small wire brush...
A mate of mine used this on his chain and measured the wear, ironically is wasn’t scientifically valid but got almost the same range out of a chain using GT85 as he did with any other lube, some older gents use 3 in 1. That’s seem to do fine. Me personall, I use the WD40 wet lube, it smells lush...
Is use a Dougie, its a contraption that weighs 35kg (77 lbs for our American buddies) it has massive teeth and makes a lot of noise. Warning it does smell bad on occasions, and you have to empty it twice a day. But it’s been great at deterring any would be intruder including the kids. This is a...
Once you eliminate the impossible, whatever remains, no matter how improbable, must be the truth. So what have you not changed, it looks like you’ve changed the following:
chain
cassette
free hub body
front chain ring
hanger
cable (all of it or just the inner cable)
then only thing left is the...
So I have an Bee mer X3, and my levo goes in lying flat with the front wheel off, with the back seats down too, in fact I can get two bikes in the back (careful not to scratch them). i have a boot liner that’s specifically tailored to the boot. However slinging a muddy bike in the back still...
Undo the retainer bolt underneath the fork steerer tube, this will release some tension it should pop out, I’d the remove it completely and clean and re grease the whole assembly, then re fit.