YT Decoy thread part 2
- Thread starter Rob Rides EMTB
- Start date
First time trying to fit the bike in the car this morning, definitely should have tried a test fit last night! I have an A4 saloon and my analogue bike slips in easily with the front wheel off. The decoy was a whole different challenge 
. The handle bars were catching the boot ceiling even on full lock, wouldn’t even fit with the back wheel off (which I prefer to not remove anyway). Ended up taking the bars off as I was running late, pretty much have to reassemble the bike after work . I was pretty careful but hoping I haven’t caught any cables/controls whilst manoeuvring it...
Think if I took the pedal off it would have been slightly easier but didn’t have my tools on me. Will have a play later tonight as I prefer to not drive around with bike racks on display. Will take the rear bench seat out as I never use it, will help the seats drop completely flat.
May need to look at a van at some point.
. The handle bars were catching the boot ceiling even on full lock, wouldn’t even fit with the back wheel off (which I prefer to not remove anyway). Ended up taking the bars off as I was running late, pretty much have to reassemble the bike after work . I was pretty careful but hoping I haven’t caught any cables/controls whilst manoeuvring it...Think if I took the pedal off it would have been slightly easier but didn’t have my tools on me. Will have a play later tonight as I prefer to not drive around with bike racks on display. Will take the rear bench seat out as I never use it, will help the seats drop completely flat.
May need to look at a van at some point.
In my case that is certainly true ?
Car does fit into car with the pedals off, so I have a work around for now. However tbh I think a van is the long term goal as I want to be able to travel/sleep in it too.
Just been on my first ride with the Decoy. Was raining and pitch black, trails were absolutely trashed but it was fucking epic. This bike is unbelievably good. It's surpassed all my (very high) expectations. If I wasn't an Ebike convert already then I would be now. However I'm also a YT fan now, everything the bike is perfect. The geometry is spot on and the components are phenomenal.
I was out for 2 hours in boost the whole time and only used 1 bar. Got an error a couple of times 043 but it cleared up with a simple reset, will look into it.
Haven't had that much fun on a bike in a very long time. I'm already buzzing to get back out on it. Few pictures before I cleaned it down:
Just been on my first ride with the Decoy. Was raining and pitch black, trails were absolutely trashed but it was fucking epic
. This bike is unbelievably good. It's surpassed all my (very high) expectations. If I wasn't an Ebike convert already then I would be now. However I'm also a YT fan now, everything the bike is perfect. The geometry is spot on and the components are phenomenal.I was out for 2 hours in boost the whole time and only used 1 bar. Got an error a couple of times 043 but it cleared up with a simple reset, will look into it.
Haven't had that much fun on a bike in a very long time. I'm already buzzing to get back out on it
. Few pictures before I cleaned it down:
Awesome mate..well chuffed for you ??
Cheers mate. The bike bailed me out on one potentially serious error. I went off a drop way to fast and landed a few feet further down than I should have. Normally I would have been catapulted off, as I wasn't ready but the Fox suspension just soaked it all up. Needed almost the entire travel though.
Sounds like you’ve dialled it in nice mate..
No such thing as too much travel hey ??
No such thing as too much travel hey ??
Camstyn
Well-known member
The too much travel thing definitely seems to be a non issue with ebikes. I had a Capra 27.5 last year and did not enjoy riding it anywhere but the bike park. Capra? Zero issues except for the low BB height, absolutely having a blast on it on any kind of trail.
I have a medium and a 29" inseam. Stand over is awesome. Very similar to my medium 2017 transition scout. Im not sure where to measure from ground to where on the top tube but it has to be one of the best choices for standover. So good i sometimes think i could have gotten a large. Decoy doesnt have the longest reach but i think that keeps it playful with the eeb ldngth chainstay(shortish by emtb standards but not by reg bike standard)
I would measure from the ground up to where you would normally stand in front of the saddle. Maybe 4-5" away from the front of the saddle to the ground?
KenX
E*POWAH Master
On my Small, it's 80cm tall halfway along the top tube, flipchip on high, I'm 29" inseam and it's perfect
Thank you for doing this. I wonder how much the standover changes when the flip chip is changed from low to high. 80 cm is 31.5", so you are probably standing behind the middle section to preserve the jewels.
KenX
E*POWAH Master
With shoes on, it's fine there! The mid-point's about where you have to stand anyway......
You just need to download an app.
don't you need a SHIMANO PC Interface/Diagnostic for that?
Nope, you just need a smartphone and a £30 app. Check the motor section on the forum ?
thankyou
SteveSSS
Member
I came off a Vitus E-Sommet small onto a medium Decoy. I'm 5'5 barefoot with a 28" inseem , bike fits great to ride but my nuts are on the top tube when I straddle the bike in shoes. Im happy with this but im not looking to have kid's.
On my medium with the fork at 170 at 4" in front of the nose of the seat(seat set in the middle of the rails) the top of the toptube is exactly 29" from the ground. Its 27" at the top of the top tube from the ground measuring right at the nose of the saddle. I hsve it set in the slack angle. Guessing the steep angle setting will raise it 1/2" ish
You have the exact same dimensions as me. Thanks for this. Do you ever feel that you should have gone with a small?
This is great info, just need a small now. I called YT to ask them for the standover and here is what they told me. S=697mm and M=692mm
It sounds like YT is measuring SOH straight down from nose of the seat from maybe the top of the rail.
SteveSSS
Member
No, never. I would of struggled for room on a small when cycling, I think.
Not sure what you mean by the top of the rail? I only said the nose of the seat or 4" in front because that is where i measured the top of the top tube to the ground. I think stand over is how much room the twins have when youre straddling the toptube standing on the ground? When youre on the pedals their is tons of room.
Sorry I meant when the seat is in the highest position.
I don't think static standover is very relevant on a modern MTB. The main thing is to have a short enough seat tube to allow the saddle to drop. I never get on or off over the top tube and when riding never get anywhere near it. It seems like having the same problem as having the saddle low enough to be able to reach the floor while seated ...
No they dont. That adds too many factors and besidees its irrelevant. Different models have different brand seatposts and drop.
Standover is measured from the ground to the top of the toptube. Where on the toptube is the question because it has to be a standard for comparison.
Low standover is indeed needed. The funnest bikes ive owned have the most standover. When youre on the pedals the bike has more room to move. Funny shapes happen, especially at slow speeds and the freedom of not hitting the toptube on youre leg helps. Short inseams appreciate it even more
EMTB Forums
Latest articles
-
A new standard for charging ebikes is coming? A quick interview with Bosch - charge2bike
I had a quick chat with dr Vikram Godbole about "charge2bike", a new...- Knut Nes
- 2 min read
- Views: 533
- Reaction score: 6
- Comments: 2
-
Introducing the Forestal e-Cygnus - a downcountry and XC emtb
The new Forestal e-Cygnus is a slightly unusual emtb. It comes in two...