NJN's Meta Power Race
- Thread starter njn
- Start date
Looks good in red , not see one in that colour , have you done any mods? , we’re having a debate that the gearing may be a bit low with the 34 front ring and contemplating a 36 or even a 38 ? Haven’t got to try any very hard climbs yet so second is the most I’ve really used
Nice looking bike. Hope you’re enjoying it 
- Thread starter
- #4
Mods are bars, stem, grips, pedals, seat, stans tubeless, shortened cables and a spring.
Eyeing the 2019 Lyrik in red. At a minimum, I would like the 170 or 180 upgraded air shaft kit.
A 2019 DebonAir upgrade kit will be available as an aftermarket upgrade if customers want to spruce up their RockShox Lyrik, Yari, Pike, and Revelation forks (MSRP $42 USD | €47 | £42).
Introducing the Updated 2019 RockShox Lyrik and Super Deluxe
Eyeing the 2019 Lyrik in red. At a minimum, I would like the 170 or 180 upgraded air shaft kit.
A 2019 DebonAir upgrade kit will be available as an aftermarket upgrade if customers want to spruce up their RockShox Lyrik, Yari, Pike, and Revelation forks (MSRP $42 USD | €47 | £42).
Introducing the Updated 2019 RockShox Lyrik and Super Deluxe
Few talking points there , I thought the bars would be too high when I saw Them but trying them lower didn’t work for me . Stem length seems ok I’ve got the seat quite far back so I don’t think a shorter stem would help me .
Shorten cables and a spring done that already, standard spring is very light , but at £25 the right spring isn’t expensive
Have you used stans rim strips or just stans fluid , I found the tubeless set up as standard was very good with the rim tapes it came with , shame it didn’t come with valves .
Going to try a 36 front ring , current gearing could be a tad low and I find Iam often between gears .
Shorten cables and a spring done that already, standard spring is very light , but at £25 the right spring isn’t expensive
Have you used stans rim strips or just stans fluid , I found the tubeless set up as standard was very good with the rim tapes it came with , shame it didn’t come with valves .
Going to try a 36 front ring , current gearing could be a tad low and I find Iam often between gears .
Last edited:
- Thread starter
- #6
I really like the 481mm reach, makes all my other bikes feel small. I was worried about the seat tube length, but my old seat is a few mm shorter than the stock volt. Stan's fluid and valves. I also was thinking of a 36 ring, but I like the clearance of the 34 for now.
The bike came with a 10sp road bike chain, not the ex1 listed. Bent one link, so it's a bit shorter now. I have an EX1 chain ready to go sitting in my toolbox. The chains appear identical with the exeption that the EX1 has a matte finish instead of polished. $2 price difference at retail.
The bike came with a 10sp road bike chain, not the ex1 listed. Bent one link, so it's a bit shorter now. I have an EX1 chain ready to go sitting in my toolbox. The chains appear identical with the exeption that the EX1 has a matte finish instead of polished. $2 price difference at retail.
I’ll let you know what the 36 ring is like ,as you say the clearance is quite tight , I think the current gearing is quite low , I have used bottom gear a few times but it’s got to be a very steep and technical climb to really need it . Hoping the 36 will raise my gears by around a half ratio that will be just right I think .
Interesting what you say about the chain , good to know a normal 10 speed will work , the ex1 looks heavier duty to me , but not compared close up as my other bikes are 11 speed , maybe the ex1 wasn’t available last year , I wonder if a 10 speed cassette would work ?
170 fork conversion sounds interesting , not sure how much it will change the front geometry and feel , it doesn’t feel particularly slack as it is so could be a good upgrade with a little more ground clearance into the bargain , not expensive iether
- Thread starter
- #8
I found the red 2019 lyrik r2c available for special order on Mountain Bikes, Components, Apparel & More | Worldwide Cyclery
April was stated as being the release time, so the kits should be available soon.
April was stated as being the release time, so the kits should be available soon.
The 36 front ring has worked well ,lowest gear is still fine for even the hardest climbing , and Iam using it mainly set on low settings in trail , japsured fitted a 38 but it’s a very tight fit
Ive use the Hope narrow/wide 36T seems to fit and run just fine
jsalas2
Well-known member
Yes, I felt they went cheap with the bash guard and also the zipped tied chainguard.
The bash guard on the Trek is aluminium.
It is plastic , which is great if it’s strong plastic like motorbike bashguards , but this is bit thin and patheticIs that plastic?The bash guard on the Trek is aluminium.
jsalas2
Well-known member
Just a heads up, check you axle pivot bolt. Mine came unbolted today, it was a third of the way out, before I noticed my rear end wobbling. Luckily the nut on the other side didn't fall out, the chain guide kept it from falling off. Glad I was on regular trail and not coming down a dh section, would've of probably ended badly. Be safe.
jsalas2
Well-known member
FYI - I contacted Commencal about the flimsy bashguard. They said they were disappointed with it also, but didn't want to delay the first run. They have already designed and approved a replacement that will become available in about 2 months. No pics, but has to to be better.
Good news on a bashguard ,
My cassette came loose too and I tightened it really well when the bike was new , I know cassettes loosening is not unusual but it was really loose , 5 th gear rattling was the first sign I guess because it’s the first of the single rings .
Kept an eye on it and it’s stayed tight since .
Fitted a new chain this week too , .75 wear at around 400 miles, it has been really mucky conditions though
My cassette came loose too and I tightened it really well when the bike was new , I know cassettes loosening is not unusual but it was really loose , 5 th gear rattling was the first sign I guess because it’s the first of the single rings .
Kept an eye on it and it’s stayed tight since .
Fitted a new chain this week too , .75 wear at around 400 miles, it has been really mucky conditions though
- Thread starter
- #29
Adjusted the travel of the 160 Lyrik to 170 with the updated Debonair air shaft.
Noticeable improvement. Less hand numbness. Plush and tracks better. Slightly floaty steering when seated, but better overall when standing and going downhill.
Foam seals were a bit dry and there was less than 10cc of oil in each leg.
Noticeable improvement. Less hand numbness. Plush and tracks better. Slightly floaty steering when seated, but better overall when standing and going downhill.
Foam seals were a bit dry and there was less than 10cc of oil in each leg.
EMTB Forums
Latest articles
-
Santa Cruz Vala X0 review - a new approach to perfection?
The new Vala is Santa Cruz’ first attempt on a Bosch-powered emtb. Like...- Knut Nes
- 6 min read
- Views: 967
- Reaction score: 4
- Comments: 3
-
A new standard for charging ebikes is coming? A quick interview with Bosch - charge2bike
I had a quick chat with dr Vikram Godbole about "charge2bike", a new...- Knut Nes
- 2 min read
- Views: 881
- Reaction score: 7
- Comments: 4