I fixed error code 550.

[lovemusicaz]

Got error code 550 on kiox display with my cx motor. Power was cutting out and wasn't charging the kiox. My friend whose an electrical engineer suggested using a hair dryer on and around the motor cos fault was probably due to water damage. I took the plastic cover off and blew on the motor for about 20mins. And miraculously it worked. Bikes working normal again ,I'm well happy. This is genuine not a wind up. My motors 4 years old but only done 1800 miles on touring mode only.

 

[Stihldog]

When I reinstalled the motor , (Bosch CX Gen4), for the first time, I applied a small amount of dielectric grease around the ribs of the rubber seal only on each motor plug (4).

If the wiring harness is good (not pinched or broken), I would suspect the main electrical connection between the battery and wiring harness (lower bulkhead). A battery adjustment procedure may be necessary for a good electrical connection. Any vibration may cause some temporary poor connection at this point.

Drying these electrical sockets would certainly help.

 

[Paulquattro]

Welcome to the forum .