E8000 motor bolt torque?

[Cubie]

Evening folks, going to be removing my motor this week to route a di2 cable on my spectral. It can be routed round but I want it to be neat and I’ve a bit of ocd.
Question is does anyone know what the motor bolts should be torqued to? I dont normally bother torquing stuff but keen to do the motor properly. ?

 

[Stuart569]

Evening folks, going to be removing my motor this week to route a di2 cable on my spectral. It can be routed round but I want it to be neat and I’ve a bit of ocd.
Question is does anyone know what the motor bolts should be torqued to? I dont normally bother torquing stuff but keen to do the motor properly. ?

 

[R120]

The full dealer manual is in the Shimano motor forum

 

[Cubie]

Sorry R120, must've missed it when I was scanning through. Cheers!

 

[Cisco]

Unfortunately, for the M8 drive unit bolts, the dealer manual says to contact your frame manufacturer/OEM. ;-)

No.

Shimano gives the torque as 10-12.5Nm. Supply of bolts is by frame manufacturer for obvious reasons

 

[RickBullotta]

No.

Shimano gives the torque as 10-12.5Nm. Supply of bolts is by frame manufacturer for obvious reasons

Ha. The PDF version I downloaded didn't have that. Thanks!