• How to use this section. To the thread starter: Once you are satisfied with the answer that youve been given, click the Trophy on the left hand side of the message. This will rate this answer as the 'Best Answer' and will change the question status from 'Unanswerd' to 'Answered'. All members can also upvote an answer with the 'Up' arrow, this will help identify the best answer.

Brose converstion to bosch motor and battery (just mainboard)

Bcr.bogdan

New Member
Jul 31, 2024
3
0
Romania
Sure, here’s the translation:

Hi,

I have an electric bike with a Brose motor (Continental) and a Continental battery. I’m wondering to what extent I could take a motherboard from a Bosch Gen 4 motor and a Bosch battery for it and put their boards into my motor and battery.

Is this possible?

Thank you.
 

Zimmerframe

MUPPET
Subscriber
Jun 12, 2019
14,028
20,818
Brittany, France
I guess something is getting lost in translation.

So you want to keep your motor and your battery ?? But just change the board from the motor and the battery ? This can't be right ?

I'm guessing you want to keep either your motor or your battery ?? and either install the gen4 motor with your battery or use a bosch battery with your brose motor ?
 

Bcr.bogdan

New Member
Jul 31, 2024
3
0
Romania
I guess something is getting lost in translation.

So you want to keep your motor and your battery ?? But just change the board from the motor and the battery ? This can't be right ?

I'm guessing you want to keep either your motor or your battery ?? and either install the gen4 motor with your battery or use a bosch battery with your brose motor ?
The actual bike has conti-brose motor and conti battery.
I would like to have something that can get updates to day. So i thought:
- keep the brose motor as physical parts and swap just the bms/board with the software from a bosch gen 4 motor.
- keep cells, connector to actual charger and replace just fhe bms/board from a bosch gen 4 battery.
 

Bcr.bogdan

New Member
Jul 31, 2024
3
0
Romania
The actual bike has conti-brose motor and conti battery.
I would like to have something that can get updates to day. So i thought:
- keep the brose motor as physical parts and swap just the bms/board with the software from a bosch gen 4 motor.
- keep cells, connector to actual charger and replace just fhe bms/board from a bosch gen 4 battery.
I have a conti-brose 36v motor with a 625wh battery.
If bosch boards can fit both inside motor and battery, it should work, isnt it ?
 

jeanmarc

Well-known member
Mar 2, 2021
446
432
Canada
Woah... Unless you are an electronics engineer my two cents would be "good luck with that"... Chances of this working are close to 0% in my view. 🙁
 

EMTB Forums

Since 2018

The World's largest electric mountain bike community.

555K
Messages
28,072
Members
Join Our Community

Latest articles


Top