Adding a screen next to EN-600-L switch

[mane]

Hello everyone
I have EP601 motor with EN-600-L switch.

I want to add a screen in addition to that - and I think SC-EN600 should work if I found that correctly online.

My question is, does anyone know how is that screen connected to the switch? Is it done automagically over bluetooth, or I have to connect cable that currently goes to the switch - to the screen instead, and one from screen to switch?

Thanks!

 

[Astro66]

The cable from the motor would currently go to the EN-600-L switch. The SC-EN600 display has 3 ports on it. So when you install it. You re-route the cable from the motor to the SC-EN600 display. Then from one of the 2 remaining ports. You run a new cable to the EN-600-L switch.

So to do the installation you'll need a :

1) SC-EN600 display
2) A new SD300 cable long enough to go from the display to where the switch is.

Here's a diagram. Obviously you are not installing the RHS switches. Just the display and LHS switch.

 

[mane]

Thanks Astro, much appreciated.
I assume there will be some documentation on those 3 ports. But anyhow, all clear now on what I need

 

[Astro66]

I assume there will be some documentation on those 3 ports.

The ports are 3 identical SD300 ports. It doesn't matter which 2 you use.