Search results

The lyrik is what I have.

I am quite happy with the mullet. I built it as a 27.5 with a 180mm fork. It was doing ok but I wanted more BB clearance. I changed it to a mullet but it was terrible with climbing with the 180mm front. I changed the air spring to 160mm. It is great.

That’s great work. Thank you. Mine painted blue. 😅

I was referring to the power delivery, not the overall power. M560 delivered the power much smoother and less jerk (less on and off) than M620, easier to adjust the assist parameters using either dpc245 display or the bessst tool. M620 has no doubt more watt power than the M560.

My M560 is louder than my M620. It is louder than any other M620 I came across even without new grease being added. The M560 one way bearing instead of the pawl ratchet and power delivery are superior to the M620.

What tools are required for bearing removal and Re assembly? Can you post pictures of your tooling? I just finished my bid with the M560. The motor is loud and even louder than my stock M620 without grease.

Did you get err44 at the end? If not, you will have to keep trying. It might take a few times.

How did you calibrate the controller? I used the C961 display.

You need to calibrate the motor after changing the controller.

Motor controller, not the display? Can you upload here some of the settings for us to take a look.?

How about no throttle and just pedaling?

Have you checked the top speed in your eggrider settings?

Check the rpm of your motor at full throttle. Here is the specs. For 52V system, it should be around 180.

My latest build with the G510 UART version has a lag when starting from full stop, more noticeable on smaller cogs. No power until the bike starts moving. My other two G510 bikes do not do that. The settings are all the same. Is it a new firmware update to protect the motor controller from...

I used one of these. I had to do some work by filling the back side with epoxy so I could secure it using double sided tape to the frame and filed it down a little so it doesn’t rub on the chain. It has not fallen off yet. 😅 The Oneup chainguide would work also with some modifications. Granted...

That sounds like a lot on the carbon frame. Just want to confirm.

For the 3 motor mounting bolts/nuts, what is the torque specs?

The throttle can be defective also. Even with the wrong settings, it should not be acting liked the way you described.

I checked their site awhile ago and couldn’t find the right battery.

Where can I order one from ding tai battery? Do you have a link?