Search results

So far I have pedaled a bit over 1000km on my Mondraker Crafty. The last couple of rides I have noticed the motor noise has randomly and temporarily gotten a lot louder than what I am used to hearing. Anyone else noticed such happening? The rides have been muddy and the motor covers have been...

Hmm could this be the cause? The cog is clearly dragging against that plastic cover.

When does it disengage? E8000 spinned pretty freely on the stand but this Bosch motor is totally different tech?

Is it normal to feel slight resistance when spinning the crank when the bike is on repair stand? And a slight “dragging” noise?

Maybe I’ll get it to Shimano and they can reset the firmware and see if it helps.

Mine has suddenly started cutting out too. The screen goes off, no motor assistance, not even an error code. It just goes off and I have to stop and restart it. It may cut out a number of times after that and then it might work flawlessly for a few hours and randomly cut out once again. The...

So, does it fit or not as the air can seems pretty bulky? If not, what about other shocks with piggyback like Mara Pro or DPX2 (upside down ofc). Do the piggybacks fit or does it get caught by the downtube? The stock Fox DPS is almost as bad choice as the 34 Rhythm fork for this kind of a bike.

2017 Jam2 ? Frame is original...

Did you ever get this sorted? Having similar problems with all of the 3 terminals.

According to Shimano that’s perfectly normal. There’s a washer that allows movement on the axle for heat expansion.

100km on the trails now with the CC and absolutely no signs of any rubbing on the frame ? plus the coil shock is really amazing, there’s no way I’d go back to air...

Yeah, ordered another spring and added some clear tape on the frame for the meanwhile so I can see if this one rubs or not. Going to keep an eye on it on the test ride.

Ok flipped it around upside down once again with the spring facing other way and got a little clearance now ?

Once I sit on the bike there’s plenty of room. Only time it touches is when it’s unloaded. Shock and spring combo should be correct but apparently not for this frame. I would need to know Fox steel spring outer diameter in the 550-650lbs range before I return the shock ?

It’s 1 to 6 turns for sag, I haven’t dialed it yet as there are other problems :D

What if I grind or file 1mm off the spring? It’s the lowest part of the spring that’s just barely touching the frame, can work a paper behind it.

Yeah, the shock is a Cane Creek DBinline Coil 210/55mm and the spring is a Cane Creek VALT 2.25”/57.1mm. What was weird is that I could move the spring back and forth on the perches with 1 turn of preload, I don’t know how tight fit it should be? Also thinking about getting a FOX spring to test...

I did, it was the same upside down too. And I measured the spring OD and it was about 54mm so it’s not even that big. And now that I fiddled a little with it the climb switch gets obstructed too... So I either need to do something to the spring or just return the shock before I’m too tempted to...

Thanks ?

Just because I have no idea, is the outer diameter different on same length springs of let’s say 450lbs and 550lbs? I could probably go down a 50...