Warped 160mm hydronic, brake disk, any advice?

[Arezprime]

Lo there, any advice on weather can be fixed or just change ?
Thanks

 

[Philly G]

If it's just bent, and in my experience even new rotors can have a small bend, then yes it can be straightened. If it is actually warped, I think replacement is the only option, because you'll just end up chasing the "bend" round and round the rotor

 

[Arezprime]

It's only a small warp, but it's very annoying,
Thanks

 

[Philly G]

Have you tried straightening it? Find the section where it's rubbing and bend the rotor gently in the required direction with a (clean) adjustable wrench

 

[Rusty]

If it is bent from a hit then possibly it can be straightened but if it is warped through heat - whether dragging it or just using it too much then there is little that can be done as if you straighten it, then it will just warp under heat again.

 

[Arezprime]

Tbh it is probably more likely a bend than warp, as there has not been any real heat put though it.