Levo Gen 2 Rear cassette problem

[Jim c]

What tool is needed size wise for the cassette on the 2020 levo my two halves move so need tightening up

 

[Mcharza]

Check this video Or there are several help videos if this is not for you, hope it helps

 

[boBE]

Cassettes on the basic Levo models have 11 tooth smallest cog "Shimano HG" type, some higher models may be XD types with 10 tooth cogs. They both take the same 12 spline tool, I am amazed that SRAM did not require a new tool. If the two halves move it may be something other than tightening, cassette lock rings don't usually loosen on their own.

 

[Jim c]

The trouble is my tool looks to be the correct spline pattern but wont fit over the sodding axle so im buggered

 

[Loe Rider]

Just as a tip, don't use the chainwhip backwards like that guy does unless you want to knacker your cassette. The fixed chain on the tip is to grip the cassette and the loose chain wraps around to hold it.

Here's how to do it properly along with a little bit of info on the cassette tool types.

 

[boBE]

Just as a tip, don't use the chainwhip backwards like that guy does unless you want to knacker your cassette. The fixed chain on the tip is to grip the cassette and the loose chain wraps around to hold it.

Here's how to do it properly along with a little bit of info on the cassette tool types.

Like some other forums (fora ?) I subscribe to, plenty of info and videos of how to do it incorrectly, thanks for posting an example of how to do it right!

 

[Konanige]

The trouble is my tool looks to be the correct spline pattern but wont fit over the sodding axle so im buggered

You may have to pull off the axle end cap first!!