Hi to all,
i have a problem. My cable for the front light was scrubbed through. The isolation is gone and there was a short circuit.
Now, after changing the cable, there is no light.
Is there somewhere a fuse, which I can replace or do I need a new controller for my M510, FC2.0, 48V, CAN Bus motor?
I have a Besst Tool (Hardware but never used) to calibrate the new controller.
Would it be better to gt a FC 2.0 or FC 2.1 controller?
Where do I get a good 1t4 cable for MOTOR <-> Light, CAN Battery, yellow Connector and Display?
PS: I life in Germany
i have a problem. My cable for the front light was scrubbed through. The isolation is gone and there was a short circuit.
Now, after changing the cable, there is no light.
Is there somewhere a fuse, which I can replace or do I need a new controller for my M510, FC2.0, 48V, CAN Bus motor?
I have a Besst Tool (Hardware but never used) to calibrate the new controller.
Would it be better to gt a FC 2.0 or FC 2.1 controller?
Where do I get a good 1t4 cable for MOTOR <-> Light, CAN Battery, yellow Connector and Display?
PS: I life in Germany
Last edited:
