Giant Reign E+ 2022 - tightening torque Engine Mount

[OAK]

Hello
I Hope that somebody can help me. I would like to know the tightening torque of the 4 screws fixing the motor in the frame.
Looking to receive any helpful reply

Best regards

 

[Rickster]

The two long left side bolts are 22nm the two short right side are 11nm.

 

[OAK]

Dear Rickster,
thank you for your support. I also found this Information on another website but it refered not exactly to Giant Syncdrive Pro 2 used in Reign 2022. Afterwards I am unfortunately also not able to remember if the bolts are different in length without measuring them correctly.
Are you 100% sure with the recommended nm ?
Best regards

 

[Rickster]

Actually looking at the heading of your post , I now see its a 2022 Reign which has the new Yamaha x-3 motor in it. The torque I mentioned is for the x-2 motor. Whether or not the x-3 is the same I cannot say. Perhaps contacting a Giant dealer may be needed to confirm for sure. Unfortunately I haven’t seen much tech info on the new motor. Good luck!

 

[OAK]

As the issue is not solved yet I am asking If there is anybody except the official Giant dealer who is able to support?
Best regards