FLYON ENDURO 8.0 DROPPER SEATPOST REMOVAL AND DIMENSIONS

[saione]

Hi again.
Does anyone knows the dimensions of the dropper seatpost of FLYON NDURO 8.0?
I would be very gratefull also if someone could explain the remouval procedure.
Thanks.

 

[All4Fun]

Haibike site said 34.9mm.
I have an Flyon too, and i think to remove the post you have to loosen the inner cable at the lever.
Put the bike upside down and remove the motor, because the outer cable/ post has to move up.
Pretty easy job, beware by reinstalling the motor for the seal of the connector, motor has to fit in one move.

See also the pdf.
https://www.bikespeed.de/Anleitungen/bikespeed_RS_Flyon_Einbauanleitung_EN.pdf

 

[Sidepod]

Correct for all of the above.

 

[Hairy bum]

I did mine without removing the motor ? I just gently pulled-the cable through …. Doh

 

[All4Fun]

I did mine without removing the motor ? I just gently pulled-the cable through …. Doh

If your lucky yes, but i know from mine that damaging the cable is easily possible too, or the electrical harness, everything is pushed in a tight fit, especially a fs.

 

[Hairy bum]

If your lucky yes, but i know from mine that damaging the cable is easily possible too, or the electrical harness, everything is pushed in a tight fit, especially a fs.

Mine has to have a new loom already ..before I removed cable … it arrived yesterday … tomorrows job …

 

[Sidepod]

I did mine without removing the motor ? I just gently pulled-the cable through …. Doh

Are we talking whole cable , outer and inner or just the inner?

 

[Hairy bum]

Are we talking whole cable , outer and inner or just the inner?

Whole cable .. had to cut one end of the inner & take off one of the outer end clamps …
If I remember I pulled the inner up through the seat post and the outer out through the hole by the handle bars ..
I did remove the cable clamp by the motor and was very gentle n slow

 

[Sidepod]

If you’re replacing the whole harness it would be good if you photograph the process and post it here. I’m keen to know how the battery connector and box actually comes out?
I’ve looked at if a few times and can’t quite work out how it’s done. Good luck.

 

[Hairy bum]

If you’re replacing the whole harness it would be good if you photograph the process and post it here. I’m keen to know how the battery connector and box actually comes out?
I’ve looked at if a few times and can’t quite work out how it’s done. Good luck.

Will do I have no idea either …. But nothing ventured n all … will poke about with a endoscope camera first …