Fitting Bosch Kiox to top tube

[speigei]

Here there is.

That looks pretty clean! Could you elaborate how you did this? I.e. what mount are you using on the top tube? How did you affix the mount to the top tube? Any details appreciated!

 

[speigei]

Is it not the same?
I've not looked at one closely but I thought it was similar.

Similar, but not the the same as far as I can tell. For example, for this OEM handlebar mount it states "Note: The 1-arm holder is not compatible with the old Kiox display." I am still waiting for my new Kiox 300 so cannot actually confirm this though.

 

[Alejandro]

That looks pretty clean! Could you elaborate how you did this? I.e. what mount are you using on the top tube? How did you affix the mount to the top tube? Any details appreciated!

It's 3D printed. Fixed with 3M. One friend sell them.

 

[Rusty]

I like the mount on my 900 Tuned - have used the screw to hold it on though as I didn't want any light fingered git pinching it if I forgot to take it off. I figure if I crash hard enough to damage it I would have done enough damage tomybody to not really care about it.

 

[speigei]

It's 3D printed. Fixed with 3M. One friend sell them.

Would love to get in touch with your friend to get my hands on either the 3D printing model or a printed copy. Are they on the forum? Would it be possible to share their email via PM? (I can't send PMs just yet because I am still new here) Thanks!

 

[Alejandro]

[email protected]

 

[deertrackdoctor]

Hi has anyone got supplier details for a top tube mount for kiox 300 Bosch smart system ?
Thanks Tam

 

[bitsky]

Hey guys,
I found also this page where they sell the similar.

MagCAD Bosch Kiox E-Tube 300 Adhesive Mount

Mount the Bosch Kiox 300 e-bike display on your top tube with this MagCAD Mount. What's Included 1x 3D printed mount. 2x M3x12mm cap screws. 1x 3M double sided pad. 1x isopropyl (alcohol) wipe. Please Note: The Bosch Front/Rear Plug Interface is typically supplied with the Bosch Smart System on...

www.magcad-designs.com