Emtb for very tall people :) - size advice
- Thread starter _Tom_
- Start date
Weight isn’t an issue, though you may want to look at a coil shock, fit is the bigger question, though there are now quite a few big bikes out there, the XL Mondrakers for example, although they run the older generation Bosch motors and are likely to be replaced with new models shortly.6’8’’, inseam 38.5’’, 225 lbs. Looking for a first emtb, any ideas or should I just throw in the towel and walk instead...
A lot of the new models being currently launched have XL sizes with much longer geometry
on an xl levo with a 34 inch inseam the stock post was right at the max
i had to use a dorky 45 degree/90mm riser to replace the zero degree/50 mm + an 80mm riser bar to replace the stock 30 mm rise for a total of 110 mm rise. This to get the seat and bars level. Something to remember also is that as you raise the seat reach increases. In my case i set the seat all the way forward, 9point8 makes a forward offset dropper
i had to use a dorky 45 degree/90mm riser to replace the zero degree/50 mm + an 80mm riser bar to replace the stock 30 mm rise for a total of 110 mm rise. This to get the seat and bars level. Something to remember also is that as you raise the seat reach increases. In my case i set the seat all the way forward, 9point8 makes a forward offset dropper
Nicolai will also custom make you a frame - they have made custom EMTB frames before, and will do so for the Shimano motor as well as the Bosch.
only 760 width
DEITY HIGHSIDE 760 HANDLEBAR /// 80mm RISE
810 but can be cut down if need be for brake lines etc
ProTaper Aluminum Handlebar, 3" Rise, 31.8mm Bar Clamp, 810mm Width, Black
DEITY HIGHSIDE 760 HANDLEBAR /// 80mm RISE
810 but can be cut down if need be for brake lines etc
ProTaper Aluminum Handlebar, 3" Rise, 31.8mm Bar Clamp, 810mm Width, Black
maynard
E*POWAH Elite World Champion
People your big just can run everywhere. Save the bikes for us 6ft midgets.
- Thread starter
- #14
Thanks, but i am not too keen to spend 9K+ on a custom bike that needs customization...
- Thread starter
- #15
That is not very kind of you...I am looking for an e-bike for more than 3 years.....:/
IanVersion2
New Member
I'm a fairly average sized chap so can't offer much direct advice, but would say looking at that photo you almost need an entire bike which is 25% bigger. 29er wheels will be a good start but I'm thinking anything 'off the shelf' will always be making do with too small really.
Edit. Sorry 25% is probably hyperbole, but 10% definitely would help.
Edit. Sorry 25% is probably hyperbole, but 10% definitely would help.
Last edited:
Ben Cathro is same height as you, but a lot lighter, however he rides a Santa Cruz Heckler in XXL
www.santacruzbicycles.com
Heckler
Our first ebike. Heckler’s not about taking things easy, it’s about making things possible. Featuring 27.5 or mixed wheels (MX) and a full carbon frame. Learn more.
www.santacruzbicycles.com
maynard
E*POWAH Elite World Champion
That was supposed to be funny a compliment. Tall guys pull all the chicks . Anyways didn't mean offence man. Sorry bro . I hope you find a bike . I love my levo ?
It's really just your height, as others have said. I'd definitely go for 29" wheels though. That should be a good starting point for narrowing down the options. Below are a couple of options I found, expensive and in Germany. I would be conscious of trying not to put too much force on the seat tube. Click right on the picture of the bikes to get the xxl versions.
www.maxx.de
www.maxx.de
MAXX Jinxx - Allmountain Fully
Das Jinxx 29 ist ein klassischer Sporttourer und begeistert in jeder Konfiguration. Seine sportliche Geometrie und sein ausgewogenes Fahrwerk macht es zum wahren Kletterkünstler und gibt ihm bergab und auch auf schnellen, flowigen Singletrails dank 29 er Technik eine überragende Wendigkeit und...
FAB 4 29
MAXX FAB 4 29 -Enduro Mountainbike Mit dem FAB 4 29 stellen wir eine supervielseitige Enduro vor, bei deren Entwicklung an alles gedacht wurde.
Last edited:
- Thread starter
- #21
It's really just your height, as others have said. I'd definitely go for 29" wheels though. That should be a good starting point for narrowing down the options. Below are a couple of options I found, expensive and in Germany. I would be conscious of trying not to put too much force on the seat tube. Click right on the picture of the bikes to get the xxl versions.
MAXX Jinxx - Allmountain Fully
Das Jinxx 29 ist ein klassischer Sporttourer und begeistert in jeder Konfiguration. Seine sportliche Geometrie und sein ausgewogenes Fahrwerk macht es zum wahren Kletterkünstler und gibt ihm bergab und auch auf schnellen, flowigen Singletrails dank 29 er Technik eine überragende Wendigkeit und...FAB 4 29
MAXX FAB 4 29 -Enduro Mountainbike Mit dem FAB 4 29 stellen wir eine supervielseitige Enduro vor, bei deren Entwicklung an alles gedacht wurde.
Thanks, I will look it up. Btw. the Nicolai front wheel on the photo is a 29
- Thread starter
- #22
Thanks, I will look it up. Btw. the Nicolai front wheel on the photo is a 29
I checked the specs...its seems that the Maxx XXL (the biggest full susp.) is smaller than Nicolai.
GrandesRoues
Member
Only 190cm here, but i can understand your problem !
I would go for a local custom builder (in steel), and the new ep8 shimano motor, 29+ whells.
You should contact https://zinncycles.com/custom-bikes/project-big-and-tall/
they have made special ebikes for the road, should be able to make an mtb.
I would go for a local custom builder (in steel), and the new ep8 shimano motor, 29+ whells.
You should contact https://zinncycles.com/custom-bikes/project-big-and-tall/
they have made special ebikes for the road, should be able to make an mtb.
Last edited:
cep32
Member
I'm also 6'8" tall but a fair bit heavier than you at 250lbs or so. I ride one of these KONA BIKES | ELECTRIC | KONA ELECTRIC | Remote CTRL that I have customised to suit me. Changes have been, 29er front wheel, both wheels DT Swiss H1700, new fork so I can run a longer steerer tube and a whole stack of spacers, 50mm rise Spank handlebar.
I went down this route as I could get the base bike for $6000 NZD which, at the time, was by far the cheapest proper eMTB available here in New Zealand.
I've found it really great for the riding I do (Nelson NZ for anyone who knows it) and the 130mm rear travel doesn't seem to hold me back from where I want to be.
One thing I do appreciate is the long chainstays. It seems to help keep the front end on the ground on the climbs (something I've struggled with for ever) and keeps the front wheel weighted nicely through the corners on the descents.
The other option that hasn't been mentioned is a mondraker. I test rode a couple and found them fantastic. Just a bit spendy for me.
I went down this route as I could get the base bike for $6000 NZD which, at the time, was by far the cheapest proper eMTB available here in New Zealand.
I've found it really great for the riding I do (Nelson NZ for anyone who knows it) and the 130mm rear travel doesn't seem to hold me back from where I want to be.
One thing I do appreciate is the long chainstays. It seems to help keep the front end on the ground on the climbs (something I've struggled with for ever) and keeps the front wheel weighted nicely through the corners on the descents.
The other option that hasn't been mentioned is a mondraker. I test rode a couple and found them fantastic. Just a bit spendy for me.
mtbboy1993
Member
why not go for a tailored build? let them build a a bike that fits you. I saw they built a bike for a 2.8 m guy, but it was not an ebike. but a tailormade regular xc bike, but they used the parts and tubing from G1. As long as it's feasible they will build it for you.
TAILOR MADE • Nicolai Bicycles
en.nicolai-bicycles.com
So far If I would get an E bike now, it would be G1 EBOXX.
Sweet bike, this one has EXT E Storia shock and the EXT Era fork the first version is pictured, but they probably use Era V2 now. Great suspension. but you can get select the parts you want.
G1 EBOXX ( same geometry as Geometron/Nicolai G1, I have one) has longer reach than GT1 EBOXX(touring bike geometry)
I would go for G1 EBOXX, it suits me. but of course I use a riser bar, and set up the cockpit to fit me.
GT1 EBOXX QLF • Nicolai Bicycles
en.nicolai-bicycles.com
But as you are too tall for the largestt frame you need to go for tailored bike, so you can select the numbers you need.
Last edited:
EMTB Forums
Latest articles
-
Introducing the Forestal e-Cygnus - a downcountry and XC emtb
The new Forestal e-Cygnus is a slightly unusual emtb. It comes in two... -
2025 M1 Sporttechnik EN 8.0 review
The M1 EN is one of four M1 models built on the same frame. Well, it’s...