Anyone running a 200mm dropper post on the 22+ PP Aluminum models?

[cody311]

The 175mm spec'd Toonie dropper on my large A30 has worked well but, I have to run about 30mm shy of max insertion and it's still feeling a bit shorter than I want. I also tend to get bumped by my seat on highly techy downhill stuff. I would rather be buzzing my tire than hitting my seat. With that, I'm looking to see if anyone has found a 200mm dropper that you can fully insert.
I found a pretty good spreadsheet but, it could use some updating.
Anyone run a 200mm dropper in an aluminum frame and if so, can you reach max insertion? (yeah yeah, that's what she said)

 

[mildbill]

Bit of a Zombie response here but I put a 210mm oneup on my XL A50 and probably can get it down to about 30-40mm from the bottom. I am 6'5" and wish I'd gone with a 240mm.

 

[cody311]

Bit of a Zombie response here but I put a 210mm oneup on my XL A50 and probably can get it down to about 30-40mm from the bottom. I am 6'5" and wish I'd gone with a 240mm.

Hey, thanks for the response on this. That's about what I have sticking out of the seat tube with my 170mm Toonie, and it's still not enough. Was your One-up the new V3 variant or the V2?

 

[mildbill]

Mine was a V2 - of note MM for MM seems to have much lower stack than the Toonie - even just the seat clamp is like 10mm lower profile.

 

[philbwy]

One up 210 V2 in my A30. It is inserted as far as possible and I can use full travel. I am 6'2"

 

[philbwy]

Bike is a large.