Adding Di2 after EW-EN100 upgrade

[stona1]

Hi,
I already removed E8000 display in my bike to have clean cockpit. Now I am using Garmin EDGE 530 with EW-EN100 only. My bike have mechanical XT rear derailleur (1x11). I am going to switch it to Di2. Problem is that after removing original display E8000 I do not have any empty ports to connect electronic right shift switch (SW-M8050-R).
Can I use Junction B Internal Wire Routing 4-Port SM-JC41 (SM-JC41) to multiply ports?

Best regards
Arek

 

[R120]

I believe there is someone on the forum who has done this, but I am struggling to find the thread.

 

[R120]

Well what do you know, thanks to the new similar threads list below, I have found it:

EW-EN100 (Junction A) - EMTB Forums

 

[stona1]

Thank you very much. It seems like that it is what I was looking for.

 

[RickBullotta]

Hi,
I already removed E8000 display in my bike to have clean cockpit. Now I am using Garmin EDGE 530 with EW-EN100 only. My bike have mechanical XT rear derailleur (1x11). I am going to switch it to Di2. Problem is that after removing original display E8000 I do not have any empty ports to connect electronic right shift switch (SW-M8050-R).
Can I use Junction B Internal Wire Routing 4-Port SM-JC41 (SM-JC41) to multiply ports?

Best regards
Arek

Yes.

 

[R120]

Have you removed the mode controlle/handlebar swtich as well? If so I wonder if you could just plug the shifter into the other port on the EN module?

 

[B1rdie]

Thats what I intend to do! Just bought the ewen100 on ebay!
It seems that there is one port for the controller on one side and a port for the dy2 shifter on the other side.

 

[R120]

yup, here's my set up, I run the mode controller on the right though.

 

[B1rdie]

?

 

[Spiff]

Can I use Junction B Internal Wire Routing 4-Port SM-JC41 (SM-JC41) to multiply ports?

There are two feasible devices that can be used: SM-JC40 and SM-JC41, they have different cable exits, so you can choose according your cable layout

 

[stona1]

There are two feasible devices that can be used: SM-JC40 and SM-JC41, they have different cable exits, so you can choose according your cable layout

Thank you.