Hi i've had a single blue light and beep on my levo which then turns immediately off so no possibility of connecting mission control in an attempt do diagnose, Is this the fault what your describing ? and did you find any fix ?
My only fix after 3 days of trying absolutely all sorts was to have bike on stand and spin rear wheel whilst turning on so i assume it is a fault code related to wheel speed sensor
well hope this helps for you if applicable or anyone who searches this fault description
Well this fix was short lived exactly one week later after a similar ride same scenario happened again and is now permanent. its now in with a specialized dealer/retailer who so far haven't been able to connect a scan tool to it and apparently under specialized advice will be replacing the power lead from battery to motor
New lead from battery to motor fitted under warranty by the amazing Don Skene Cycles Cardiff and yesterday its been through a tuff 28.5 miles ride of rain, mud and more rain followed by a good bucket and sponge wash and all is good.
Can anyone expand on this issue please? My 19' LEVO has this exact issue; turn the bike on.... the bottom blue light flashes once and then beeps as the TCU turns off
Any fixes? or is it another bloody trip to the dealer......
Cheers[/QUOTE]
Check your power cable at the 90 degree end where it plugs into the motor, see pics in earlier post . It’s likely split allowing moisture in. If it’s split it will be obvious. If not it may be the TCU is damp