Search results

That sucks, not sure how you might remove them, Maybe a drill is you best bet. I snapped one of the shock bolts trying to torque to spec, I found the bolts are quite weak but when speaking to Jean they said they would make them stronger for future. I now use these TI bolts from Ali and they have...

Ha D I had a similar problem with the CEF50, I got some TI bolts from AliExpress and they've been awesome.

I don't have any major problems with my firmware or battery, I do notice the battery drains quite quickly during rides though I burned through about 70% riding roughly 30km and 2500ft on boost . I have read the 2003.2 FW worked well for a few people that had the 36v system with more power and...

No sorry, it's just what my motor and controller shipped with.

Can anyone tell me whether it is worth buying the Besst tool to tune and update the firmware on the m820? I currently have version CRX30PC3615E102002.3 installed and am trying to figure out if there is much of a performance gain.

CEF52 in action

Are you running you offset bushings in reverse? I tried this but found they would eventually spin back around after some riding.

I had a similar problem I have the cef50 with the power button on the frame. I went through and checked all the cables and still had the same issue. I got it to start working again but now when I hit the power button on the frame I immediately need to hit the power on the display, if I wait more...

Thanks, I'll be reinstalling soon and see if I can't get rid of it.

I thought about that, it's so annoying. I'm curious if it's the frame or if another headset would eliminate the issue

Using the nukeproof ZS56 on the top and just the stock bottom bearings and cup that came with the frame. Really off putting,

I seem to be having excessive headset creaking I've taken it apart and regressed the bearings but after a few rides it persists. I even reinstalled the bottom cup as I thought it may be the culprit but after a few rides I get the same creaking again. Any suggestions? I'm using the nukeproof...

this happened to me a few times, I use 2 small zip ties on the sensor plugs as collars then another zip tieing them together. Haven't had any more issues. Also make sure there is slack on either end for some play.

Epic! you should sell these.

Has anyone found a solution for the motor cover yet? Mine finally broke yesterday.

The connections mostly, after the first time I made sure there was plenty of slack either side. Then it happened again and I used cable ties to secure those plugs. I went riding today and this time it was the yellow battery connection so I've used a rubber band to keep tension on it. It's a...

Is anyone else having motor connection issues?, I've had cables rattle loose like 5 or 6 times now... having to take the motor out everytime is a massive pain. I ride pretty rough terrain and after 1 good ride it's usually rattled loose again I would assume that most manufacturers use clip in...

Nothing yet, talking to Jean about a replacement and some spares at the moment. If there was somewhere local I could have some made I would do that.

When re greasing the linkage today the end of this bolt snapped, I recommend being careful tightening them this was with a torque wrench at 12NM. This is my only problem so far after 100km of riding. The bike feels amazing, this is my first ebike so I don't have much to compare it to other than...

yeah, Mine also uses the top tube switch. I also have found the charging cable to be super tight I really have to muscle it on every time I charge the bike.