Have to second this comment.......
I recently started using a hanger alignment tool that was given to me ages ago by a buddy who emigrated ( loads of how to's on YTube ) and was somewhat surprised by how misaligned the hanger was as it looked fine to the 'eye' and had not taken a big knock...
Hey Allan
I've had my Kenevo for nearly a year - Luv it - only issue thus far was rear wheel play which was after warranty bearing replacements eventually tracked down to problems with the hub itself, wheel rebuild onto a new hub sorted it.
Good luck.
Bit of a first world dilemma.....
I have some Cycle to Work funds burning a hole in my pocket and can't decide between either of the above forks or maybe a set of Carbon Rovals....
Erring towards the forks so which ones any advice / advantages folks regarding either??
Thanks.
Good question, no idea re mileage I'm out on it most days. Reckon I have a robust chain cleaning and lubing technique going as other bike chains last a long time.
Going to make more effort to use higher cadences and less grinding, see how that goes.
Hi folks
My Kenevo is on its third chain over 6 months of ownership.
Noticed yesterday new chain occasionally jumping on the 4th & 5th (17t & 19t) sprocket.
Anyone got a good source of individual sprockets that are not £25 a pop as an entire cassette is £50.00
Thanks.
NB Stock Kenevo Expert...
Hey guys
Has anyone managed to track down a source of those BMW Levo chargers, thinking that one of those coupled up to a leisure battery is going to be less hassle that using an inverter, although the 2amp charge rate ain’t great.....
I'm same height 6'1/2, Jeans 34", ride the XL Kenevo.
Perfect reach for me, plenty of space to move around and feel really well 'sat in' the bike.
Dropper is down on the seat tube and I rarely use it at full extension.
Will at some stage change the dropper for one with less stack, other than...
Good luck I hope you are able to re educate the necessary people and over turn those restrictions.
For some inspiration check out how the Miami Beach Kitesurfers got organised and managed to recently prevent a ban on their local patch.
Actually its not really as bad as it looks as all the motor connections were bone dry and clean internally.
Take a note or picture of cable polarity if removing motor as key on plugs preventing incorrect install is very subtle.
I used foam (sponge) to close off the cable entry points in a...
I did see a post (by you?) where foam had been used to keep out mud, pine needles, grit etc but allowed water to wash through......think I will go down the same route.