Vorni
New Member
I’ve picked up a 12moth old Nukeproof Megawatt 270 Factory. It’s a complicated bike and so much more than my Whyte G160 Works. The controller is the Shimano SC-EM800 L assist switch (2 button) and the display is the new SC-EN600 which has no buttons that I can see. Apart from using the controller to change from off/eco/trail/boost, I can’t get it to do anything else. How do I use the two button switch to make other screens visible? Or even go into the set up and make changes there? Research in the internet says I have to use the Shimano Ride Project App, but I can’t connect the app to the controller or screen. Frustrating as I can’t find any info on you-tube on this.
