Shimano Di2 not registering on 7000 display (or shifting)

[TransAmMan]

Hey All

Went out for a ride tonight and just after lifting by bike by the seatstay to carry across a creek, I noticed that my Di2 derailleur was no longer registering on the display unit Just shows "M" rather than the gear the bike is in. Will also no longer shift either.

I did pull some of the cable out by accident when lifting the bike and was wondering if anybody knows if there is a connection or junction box just inside of the frame (above the motor) that I may have dislodged a connection? Perhaps there is a junction box near the battery and I dislodged the connection ??

Before I pull everything apart and start tracing cables, does anybody know where the cable entering the motor area just up from the seat stay actually connects
?

All other connections to derailleur and display are fine .. so it must be dislodged inside perhaps by my hand grabbing and stretching the cable at the seatstay.

Any advice would be greatly appreciated

 

[TransAmMan]

Well I started to troubleshoot and here I am 2 hours later with the fix ...

YES the cable clips on the TOP of the motor. I had to pull the battery and motor to retrieve the cable and re-clip it. The spot was quite obvious where it was pulled out.

Be VERY careful if you accidently pull on the DI2 cable on the seatstay ... this was a REAL PIA for a 2 second cable re-clip.

Cheers