Levo Gen 2 How freely do your cranks spin backwards ?

DuncanDoughnuts

Active member
Apr 2, 2018
315
171
Cape Town/JHB/Rippon
So I had the bike in the stand I happen to spin the cranks backwards and notice a crunchie sound coming from them every 1/4 of a revolution... I would assume that perhaps there is some water in the bearings ? They also do not spin as freely as another bike I tested.

How can I clean the and re-lube the bearings as its all in the mother casing? Or I just keep riding it and get it replaced once it seizes ?

In the mean time I took a old Enduro seal BB cover and put it on the crankshaft under the Plastic motor cover to stop any more moisture getting in there ....

ANy advice on how I can get my cranks nice and smooth again ?

Thanks
 

KennyB

E*POWAH Master
Aug 25, 2019
824
564
Taunton
To take the chainring off you just need an Allan key. If you mean take the spider off, I believe you need a puller plus a Brose spline cover (S175300006) too avoid damage to the bearings - apparently quite expensive.
 

DuncanDoughnuts

Active member
Apr 2, 2018
315
171
Cape Town/JHB/Rippon
To take the chainring off you just need an Allan key. If you mean take the spider off, I believe you need a puller plus a Brose spline cover (S175300006) too avoid damage to the bearings - apparently quite expensive.
Of course it will be expensive ..... it’s specialised . Let me try clean it up without taking it off...but you can’t get under the plastic motor cover without removing the spider..
 

KennyB

E*POWAH Master
Aug 25, 2019
824
564
Taunton
Of course it will be expensive ..... it’s specialised . Let me try clean it up without taking it off...but you can’t get under the plastic motor cover without removing the spider..
I just googled the part number and not that expensive. Don't know about your part of the world though.
 

EMTB Forums

Since 2018

The World's largest electric mountain bike community.

552K
Messages
27,921
Members
Join Our Community

Latest articles


Top