argee1977
Member
After the last couple of mechanical issues with my 160 TM, as of last week it just stopped working, with the error code 503 popping up and just allowing the motor to use a very rough limp home mode.
I've checked the magnet, it's fine, tried a back up, same thing, position is good, as are all the wires and connectors to the motor, but it's just not working, and unfortunately going back to base for repair, so another few weeks without a bike.
Anyone else suffered this on a 2020 Cube with the Gen 4 motor?
I've checked the magnet, it's fine, tried a back up, same thing, position is good, as are all the wires and connectors to the motor, but it's just not working, and unfortunately going back to base for repair, so another few weeks without a bike.
Anyone else suffered this on a 2020 Cube with the Gen 4 motor?
