So i'm collecting my E010 badge here 
A while ago i was getting occasional the E010 error on my kona mtb with E8000 system, mainly when riding boost mode. But if i ride e few 100 meters with motor of end restart it was all good again. Now last weekend i went to work on my bike, a 30km trip. After 15km E10 fault and it wouldn't go away. So 15km to work and 30 back without assist, good training . This week i checked google so i did the following:
- Cleaned all contacts and used contactspray
- Have 2 batteries and the problem is with both
- changed front cog with stunblocker from 34 to 32 and back
still fault E010 immediately when i start up the system.
I was already thinking ok 1000€ for e new motor, tomorrow to the LBS.
Today before going to LBS i start up the bike and wtf it works. Small test ride of 3km, no problems.
What was the cause of this?? i don't know, is it solved probably not..
Are there any other tricks that i can do if it comes back??
A while ago i was getting occasional the E010 error on my kona mtb with E8000 system, mainly when riding boost mode. But if i ride e few 100 meters with motor of end restart it was all good again. Now last weekend i went to work on my bike, a 30km trip. After 15km E10 fault and it wouldn't go away. So 15km to work and 30 back without assist, good training
. This week i checked google so i did the following:- Cleaned all contacts and used contactspray
- Have 2 batteries and the problem is with both
- changed front cog with stunblocker from 34 to 32 and back
still fault E010 immediately when i start up the system.
I was already thinking ok 1000€ for e new motor, tomorrow to the LBS.
Today before going to LBS i start up the bike and wtf it works. Small test ride of 3km, no problems.
What was the cause of this?? i don't know, is it solved probably not..
Are there any other tricks that i can do if it comes back??
