Hi everyone.
Thank you for accepting me into your group.
I have BMS controller AST-01 G/B 112-3458F to repair.
I checked it and found out nothing damaged except FUSE. I understand that AN49511A and R5F2134 must be reset.
Probable I have RENESAS programmer, but I don't understand how make it without full dump.
Despite of that fact, I tread to replace AN49511A from another BMS (not the same) which have given to me the owner.
(Sorry, I am not EMTB user, I am engineer).
So, would somebody help me to advise what way is correct?
From the pictures is obviously that AN49511A send to R5F2134 ALARM and FAULT.
R5F2134 Does not allow AN49511A to start.
Beside on AN49511A has Address: 0x10 (Status Register) that can be changed (HOW).
I would be appreciate any help.
Thank you advance.
Thank you for accepting me into your group.
I have BMS controller AST-01 G/B 112-3458F to repair.
I checked it and found out nothing damaged except FUSE. I understand that AN49511A and R5F2134 must be reset.
Probable I have RENESAS programmer, but I don't understand how make it without full dump.
Despite of that fact, I tread to replace AN49511A from another BMS (not the same) which have given to me the owner.
(Sorry, I am not EMTB user, I am engineer).
So, would somebody help me to advise what way is correct?
From the pictures is obviously that AN49511A send to R5F2134 ALARM and FAULT.
R5F2134 Does not allow AN49511A to start.
Beside on AN49511A has Address: 0x10 (Status Register) that can be changed (HOW).
I would be appreciate any help.
Thank you advance.
