Bramco
Member
Hi,
My Levo has gradually started cutting out when I'm riding - it's now at the stage where when I start riding it will run and then after a 100 yards or so will slowly give less power until it stops. If I turn the battery off and on again it will work as above. When this first occurred, it would drop out for a while and then go back to normal, so it's worse now than when it first started.
I've replaced the wiring harness from the battery to the motor - the socket on the motor was corroded but this has been cleaned up. I'd assumed it was this cable that wasn't connecting properly. An expensive non-fix!!
The battery has been charging normally and is fully charged - and there's a voltage on the big pins on the wiring harness, so I'm assuming the battery is OK - or is there a voltage test like the one for a car that would indicate a failed battery?
I use BLevo and can see from the interface that cadence is as expected as well as rider power and bike power. Obviously bike power starts high as above and then drops back to zero when whatever is wrong causes the power to stop.
Would be great if anyone else has had this and could shed some light on what the issue is.
Thanks in advance
Simon
My Levo has gradually started cutting out when I'm riding - it's now at the stage where when I start riding it will run and then after a 100 yards or so will slowly give less power until it stops. If I turn the battery off and on again it will work as above. When this first occurred, it would drop out for a while and then go back to normal, so it's worse now than when it first started.
I've replaced the wiring harness from the battery to the motor - the socket on the motor was corroded but this has been cleaned up. I'd assumed it was this cable that wasn't connecting properly. An expensive non-fix!!
The battery has been charging normally and is fully charged - and there's a voltage on the big pins on the wiring harness, so I'm assuming the battery is OK - or is there a voltage test like the one for a car that would indicate a failed battery?
I use BLevo and can see from the interface that cadence is as expected as well as rider power and bike power. Obviously bike power starts high as above and then drops back to zero when whatever is wrong causes the power to stop.
Would be great if anyone else has had this and could shed some light on what the issue is.
Thanks in advance
Simon