160RS - Magura MT7 Pro Brakes

[Geetsrevoel]

Hi, I’m looking to fit Magura MT7 Pro brakes (when there is more stock)to my E160RS.

I’m looking at 220mm front and 203mm or 220mm rear rotors.

Can anyone please advice the best way to go about selecting the calliper mounts?

I have been on the Magura website but I just can’t make sense of it with regards to what ‘post mount standard’ I have etc.

Guide attached

 

[d4ve86]

For the front with a 220mm, you need the Magura QM45 adaptor.

Using a 203 on the rear I have two little spacers under the rear bolt, I will post a picture later and the total thickness.

I had the floating Magura MDR-P rotors, 220 and 203 swapped them for Galfer 223 and 203 as they made a lot of noise, prefer the Galfer ones. I'm still on the standard Sram Code brakes at the moment.

 

[Geetsrevoel]

For the front with a 220mm, you need the Magura QM45 adaptor.

Using a 203 on the rear I have two little spacers under the rear bolt, I will post a picture later and the total thickness.

I had the floating Magura MDR-P rotors, 220 and 203 swapped them for Galfer 223 and 203 as they made a lot of noise, prefer the Galfer ones. I'm still on the standard Sram Code brakes at the moment.

Thanks for your response! Those pics would be great help ??

 

[d4ve86]

This is what I ordered
GALFER 223mm Disc Rotor 2mm Thick DB007W
GALFER SB001 +43mm Post Mount Adaptor SB001
GALFER DB004W2 203mm Rotor 2mm Thick DB004W2

The Galfer discs are a lot lighter than the MDR-Ps

The SB001 mount came with 2 washers that I used at the rear, under the rear bolt, lines up perfectly. Picture below -