Search results

hello everyone, here is mine with a loud ticking noise, LBS is trying to fix it but i don't know how/when.

me neither, i believe it's easier to swap the entire wheel and get one native XD.

hi all i got those wheels on my trance e+ 2020 3 Giant AM 27.5 Aluminum Tubeless 27.5" Wheelset i would like to swap the cassette from PG-1210 to XG-1275 but this one only installs on SRAM XD Driver. the wheel has now a standard Shimano driver, so the question is: can i also install the SRAM...

Thanks crawford919 you can’t imagine the struggle when replacing the rear brake tube...

So dropping the Engine is matter or unscrew four bolts? I’ve tried but not successfully, two bolts on the left and two on the right but engine didn’t move at all!

yeah i'll give it a try. i feel inertia when compression start, and then suddenly the fork start compressing, no smothness at all. it's bad feeling at the end, but fork upgrade is also a lot more expensive than brake upgrade i did.

which issues is she experiencing with the GOLD 35? i also have it in the e+ 3 pro, and honestly i feel it not sliding well at the beginning of compression phase (if you got any suggestion to improve more than welcome). i know it's basic range for a fork, but there's also a lot more cheaper on...

dears, is there a list of Garmin watches that are compatible with this app? i see the fenix, but are there other (smaller) models?

ouch, so you are saying that f****g ticking noise ended up in a replaced engine? :eek:

i also have the tick when i push on left pedal, it was very slightest sound initially, now i can clearly hear it anytime.

i don't know but in any case i wouldn't like to mix tektro and shimano components, moreover to detach the old line from the framei pulled it firmly, i saw that it was strongly compressed in that point between frame and engine, so better to avoid re-using it. anyhow, i did use the hole on the...

hi all so i'm in troubles again and it's about the lenght of the cable for the rear brake. i've got a SM-BH90-SBS of 1700mm lenght and it goes out from the frame on the left, or better, it should come out from the left hole in the frame together with other cables (ridecontrol and dropper). BUT...

D01S and no rattle

So at some point I've unmounted the battery connector as in the video, and pulling the cable was enough to detach it from where it was attached, it seemed like glued to the engine! Now the cable need to pass upstairs where is the battery key lock, attached a picture Ciao!

Seen that one but in my case engine does not come down, thanks a lot anyhow

Do you know of also the crankset must be removed? I was able to get 4 bolts out, two on the left and two on the right that are going into the frame (torx t30) but it does not move at all.

Hello everyone, I would like to share my concerns about a brake swap procedure I'm stuck in. I decided to swap my tektro's with a Shimano Zee set mostly because finding a way to deal with covid-19 and get busy somehow. For the front I've got no problem it's already installed. For the rear...

Hi all I'm looking for advices on giant trance mechanical issues, but willing to share my experiences as well. Thank you all!