Hi there, yes i received it, it was more expensive as timals option, as i could not order it directly from wheeltop. The eds works great, you can adjust every gears position manually, so it is precise. When not using it it goes into some kind of sleep mode and then when you move the bike it...
Does anyone notice the bending of the rear triangle/rear forks when accelerating hard, at least when using higher powers? I have innotrace version set to cca 2200W when battery is full and when using higher assist levels or throttle on asphalt you do notice a bit of bending of the rear which...
I would also change my rear HUB for less speeds, I have 12 speed microspline cassete, but as i know only 11 or 12 speed cassetes are available for this hub. With g510 you need lets say 8 gears max and thats it.
I ordered it in november, received it in december, about 14 days they needed to ship it and a few more days to get it to my address. Unfortunately I also have to say their replies are a mess! Still waiting for advanced password to enter correct wheel diameter and waiting for them to ship light...
Man, I have to try these paswords, thanks! I also have the same stuff from innotrance as you, unfortunately their responses are very bad and still got no answer from them about this password, even though I emailed them at least three times how to change wheel diameter!! Btw, my stickers on the...
I also need one of these! This german site does sell it, it is expensive however. It is made by 77design, but on their webpage (where they also have estore) this guide cannot be found:
https://77-store.com/en/
I am not sure if it is compatibile with microspline shimano rachet/chainring and/if manual adjustments are possible if there is any offset between shimano and sram gears..
I did placed an order for wheeltop eds, it was 410€ without vat on aliexpress, just hoping it gets through customs without...
It happened when he hit the snow and the bike suddenly almost stopped, he hit the throttle and then you can imagine what sounds he was hearing. I already contacted Timal, but got no answer, will look into some videos on youtube if there is any other store mentioned to buy it from.
However I did...
This happens when your nephew takes the bike to a spin, but you still havent set up the rear derauiler.
There were a few gears where the setup was a mess, so i am looking for that EDS from wheeltop (i saw a video where you can set every gear individually via app). Anyone has any good source to...
They lean on the motor mounts anyway, so with tightening them you just press them together (motor holders with motor mounts), so the material should not suffer. But double check that there is no space between them prior tightening.
Directly from Innotrace yes, it took them cca 14 days to ship it + a few days to arrive. I also ordered programming cable, but have not tried it yet - have some error on my old laptop, that is why.
I have an Innotrace M620 with I think Motul grease (an option when ordering) and I have to say the motor is just slightly louder than Bosch, I was surprised in this regard.
I am wondering how does this thing start? So I sit on the bike and you need to press/hold a button for it to connect (shifter on the bar with derauiller)? What is the delay in connection and if it is maybe annoying to wait for it?
What is the purpouse of that little button beside the keyhole? I connected all the cables , but this button has no effect, it should probably be on/off switch?
I suggest a group buy, I believe the shipping cost could be minimum, if divided by at least 3 or 4 people. M620 is heavy like a motor on my moped, that is why shipping is quite high. I am not sure about the controller itself, is it just plug an play if you already have the motor from local...