I've managed it - just takes quite a bit of force on the larger metal right hand cog above. Watch out there are seals in the bottom of each recess!
Example here:
Now I can "try" some home made water proofing...
How do I pull out the gears from inside the ep8? (Not the main bearing and axle) I've seen a video and it looks like they snap out but I've been pulling hard and no such luck.
Am I missing a trick?
So far I've had over 1500 miles out of this drivetrain and it's still going strong.
However, I'm looking to replace full drivechain soon with same parts, M6100 cassette, chains, etc. I'm not sure what part the 34T chainring is though?
It does seem very solid with little wear so I'd guess it's...
Yes CR will provide cost refund for the bolt but would not provide a link or any specification.
Looking at the one in the previous link, the shank does not look long enough? From my observations the current bolt shank is around 20mm and needs an extra 12mm. As previous posters have...
After onwning my Somment for a month I had this issue and it got worse and worse from once on a ride to around 20 times in a three hour ride. Sometimes when I got the E020 code the bike would not turn on again the Shimano startup displayed then turned off again and I had to ride in heavy manual...
Thought I'd share my very recent experience of carrying out this procedure.
Feeding the cable through wasn't too much trouble: Removed battery and mounts and used a tool made out of a cable tie.
Connected the Fuse light as expected red to positive and black to negative behind the non-drive...