Recent content by unclezz

1. Are you 100% sure that the leak is there? There is no rubber sealing on the bleed port of the Magira calipers and having leak in that sopecific place is extremely uncommon. Maybe try to replace only the screw. They are easily available. 2. No o-ring is needed. Actually it can be even...

This is THE only way to bleed properly Shigura. But for whatever reason I needed to repeat it tens of times one of the bike and on the second bike where I am having troubles just does not seem to work... on both calipers :|

Very good points. I am looking at it even in S size, so it should be llighter. And with the smaller battery. Eventually using the range extender you get 630W, although you cannot use it full power with the extender. However I was calculating the RAD of this bike and I cannot ride it even in...

Thanks! It's pretty heavy. Even with the 630 battery I expected to be in the lower 40, not close to 50 :)

Looks beautiful! I guess you are on the 630Wh battery?Have you ever checked the weight of your current setup?

Never did that. I always install the funnel first 🙂 I think I am going to buy some hopetech most probably. And will have them installed by a LBS.

Yep, that is how it should be. But I cannot believe I have 2 out of 2 faulty levers :|

I acvtually happen to learn that with Shigura it is best to bleed them with the bleeding port on the caliper completely closed. Just using the lever port. And in fact a lot of air came out using this method on the other bike (as well as on this one).

This is the interesting part. I just completed one more bleeding a few minutes ago and there is absolutely no air coming out. Still, the levers feel spongy and there is an important difference in braking power between the 2 bikes, where I have the exact same setup. Even just testing without...

Nothing in the news. I think Shimano did not present new products at the Otter Classsic 2025 :|

Thanks! But they are way too expensive :(

Hello! What brakes would you go for to replace a Shigura Setup? Should I go XT calipers? This winter I swapped the mt7 levers on both my bikes to Shimano XT levers. Magura levers are too weak in my opinion and I found them extremely inconsistent. But I am having a lot of troubles getting a...

[sarcasm ON] I had the opportunity to have a look at their Jira instance. After the Levo Gen 4 came out, they will be speeding up the release of the app with the fixes you are asking for. Estimated delivery time: May 2038 [sarcasm OFF] I personally only use the app to check how many total KM...

No doubt about that. But I would love to see a Shimano derailleur on a Shimano cassette 🙂

Let’s see if Shimano presents the new products at the Sea Otter event… it starts tomorrow!