Recent content by iJak

Hey Arethustra, Planning on a Telum shock too since they are local to me. Your 420lbs spring is surprising to me too as the recommendation from Crestline states ~450lbs for 180lbs. These numbers puts it in different Sprindex rates, so I wanted to double check with you on what type of riding you...

Ep8

Current setup is 46lbs / 20.8kg but nothing is stock now. Nobl Tr35s on Hydra i9 with Berd Spokes Cascade Link with 210x55 sprindex'd Bomber CR Coil Same Fork Dominions A4 with 223 / 203 Galfer Rotors 160mm Shimano Cranks XT + AXS GX OneUp 210mm v3

Wanted to revist this conversation. For those who have the SX motor, is any tuning adjustment on the app that will help with achieving the 600 watts at a lower cadence? Will the app help make this SX motor feel more inline with full powered ones? I can't find anything on the app tuning of SX...

Removal of old link was pretty straight forward. Installation of new link was good until I had bolt in the seat stays. I got one side installed but it was quite hard to align - stripped first thread of the bolt. The second side was even harder. Solution is to loosen the rear axle, and if you...

Upgrade box - will eventually report back on how everything goes..

Awesome thanks for the update! Did you have to up your spring rate by 50 or so lbs?

How about now - Got it installed? What's your take on it so far and size of bike + full 29 setup?

Planning my 2024 purchases and looking to get the link too. What size bike are you running? Also did you get the link installed yet with 29 out back? what's the clearance like?

I don't ride very often - bought it back in april 2022 and unlocked it after 200km, still going strong after 1500km! I did suffer from random power downs before unlocking, but I removed the motor and replugged everything to make sure it's nice and tight + no cables were pinched. Didn't have any...

It's happening - no details on it though. Saw this through their IG showing this at the Crankworx Whistler Booth. Below are all educated speculation: + progressivity + travel (possibility, if so, not much) Gen 1 Rise (up to 2022) - should fit both carbon and hydro Gen 2 Rise (2023 edition) -...

I've had both - Vesper Nobl 37 and now Hydra Nobl 35 on my Orbea h30. Vesper: Like any Vesper, there's going to be a bit spongy-ness when stepping on the cranks, but honestly it's not noticeable if you actually ride the bike instead of holding rear brake and cranking. Based on my understanding...

You cant unless you have STunLocker premium, or fully unlocked shimano software (I think only dealer can install this) TBH you won't be losing too much speed ~ 5 to 6% difference between 29" to 27.5" eg. speedometer display 25mph, at 27.5 actual = 23.75 mph

Just the regular ep800 RS. Sorry to clarify - when I was playing with the unlocking firmware, I had the above profile 1 and 2's torque set, Then adjusted power to 350w - flashed back to RS firmware, tested profile 1 flashed to unlocking firmware adjusted power to 500w - tested profile 2. Between...

My H30 540w Rise definitely "feels" full fat when unlocked, this is my current setup: --RS profile-- Profile 1 eco (350w - 29 nm) Profile 1 Trail (350w - 47 nm) Profile 1 Boost (350w - 60nm) --unlocked ep8-- Profile 2 eco (500w - 60nm) Profile 2 Trail (500w - ~75nm) Profile 2 Boost (500w -...