Bosch Gen 4 motor mounts ?? Does anyone know where I can buy them ?

[djmeeg]

Hi everyone, I have a cannon dale motterra 3 which has the bosch gen 4 motor. One of the motor mounts i think is threaded and the motor isn't seating right. So I ve ordered new set of motor mount bolts, but i am pretty sure i will need to replace the motor mounts which contain a rivet and m6 thread for the motor mount bolts to screw into.

I can find anywhere online or any information regarding these parts or parts number. If anyone knows where i can order them from that would be a massive help as i am bit stuck at the moment.

I uploaded photo just for reference but you can see the mounts top and bottom of the motor. I just want to replace the mounts on mine

 

[Zimmerframe]

Looks like the same mounting plates as the Trek Rail uses :

Creaking/clicking from motor area

Hi All, I have a creak/click from around the motor/BB area, mainly from load (doesn't need to be really heavy load), it seems to be left side related, i.e when I push on the left pedal. I can invoke the noise by push down with my hand on the left pedal when the crank is at the bottom of the...

www.emtbforums.com

The theory is that these are supplied from Bosch like that with the mounting plates already attached.

This thread might help too as someone there (last post I think) shimmed the plate out a bit.

Anyone else with a rail Carbon frame notice this..

JUst swapped out carbon wheels, and whilst test riding in backyard notice the chianstay was moving a bit while pedaling, then I notice the entire bosch motor was too. not massively but not rock solid. Not sure if its always done this but I dont believe so.

www.emtbforums.com