Zimmerframe

Zimmerframe

Subscriber
MUPPET From Brittany, France
Joined
Messages
14,028
Articles
6
Article comments
49
Media
13
Reaction score
20,817
Points
443

Profile posts Latest activity Postings Articles Media Albums About Post areas

  • pragrick
    Any ideas? You have always been helpful and knowledgable, it would be appreciated if you could see my post on my new brakes, not sure where to start?

    Magura MT7 - pulsing and clunking

    HI, put my first non shimano brakes on my bike, Magura MT7 and MDR-P rotors. Thought I would try something new. I never had an issue with Shimano (after 15 years and 8 bikes), never.... But you know, I wanted to give it a go because they looked good. On my first ride I bedded the brakes, had...
    www.emtbforums.com www.emtbforums.com
    S
    Salut, j'espère que tu vas bien.
    Il me semble que t'avais répondu à ma question M820 ou M510 mais je retrouve plus la réponse ? pourtant c'était pertinent il me semble ? J'allais rebondir et te remercier
    En te souhaitant une bonne soirée :cool:
    F
    Evening mate,
    Ok if I pick your brains, as you seem to be the font of Bafangery!!!
    Have had a emythique VR since mid August , same as you saw it as a potential diamond and put a Zeb and Code RSC,s on it and looked forward to a reliable bike as it couldn't be any worse than the EP8 Sommets I had previously.
    F
    FJ1200a
    I have done 196 miles on it and everything has gone well (apart from a replacement display which needed changed 30 miles in as the bike would not power up consistently)
    F
    FJ1200a
    However on Saturday past the bike would power up but displaying a fault code 35 and 05, bike would ride with power intermittently but more concerning it would drive without any crank input. I have dropped the motor and all plugs are dry, intact and shiny (no corrosion)
    F
    FJ1200a
    However if I drop the chain off the spider there is a considerable amount of resistance when rotating the crankshaft as if pedalling. I am wandering is this due to water ingress affecting the bearings and maybe affecting the controller.
    I am reluctant to ship back to CRC warranty in case they go pop and I then lose the motor.
    Your thoughts would be appreciated.

    Cheers,
    Murray
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top