Recent content by silles

I added this dropper post recently: https://www.decathlon.es/es/p/tija-de-sillin-telescopica-diametro-31-6-mm-recorrido-100-longitud-320-mm/_/R-p-199331?mc=8521875 very happy with it, no cables, so super easy to install, and very cheap for 70 euro. probably tubeless setup next?

maybe give this guys a call? eBike Motor Repairs & Servicing - Homepage

Never, unless electrical issue. I do my own service... Minus electrical its a normal bike Torque bolts after a few rides. Check chain stretch, lubricate chain etc Service lower lag about every 600 miles. Never done uper lag, dont see the need. What else, check brake pads change if needed. Etc

Trance X E+ 3 (2023) | Bici | Giant Bicycles España for 4999 euro Or Stance E+ 0 Pro (2023) | Bici | Giant Bicycles España for 5499 euro Don't understand why the better maestro suspension Trance is cheaper They both have the same forks, similar battery, etc What am I missing?

Thanks you so much for confirming... I don't have a bike yet with that motor, just planning to buy. Its reassuring to hear that motors are improving

@Bearing Man From the FAQ: "Yamaha tend to use a grease that dries out or disperses over time. After approx 1,500 miles they could normally do with a cleanout and refresh. This quietens them down quite a bit. Obviously if bearings are beginning to fail, this will also increase noise." does...

actually got to the bearing, pulled off the black caps/cones. they seem fine. filled up with grease ... however the when I tighten it up in the fork there is still a play. No idea why.

does anyone know if the front wheel bearing are servicable or not? They seem to have a bit of a play now, but couldnt figure out how to take them apart. 🤔

Took it back, got a brand new motor, thumbs up for Decathlon Ondrara. anyone installed a dropper seatpost? looking to get one, but no idea where to start

just after 1 year the motor started to click/clank when turning/adding weight to pedals. First I thought it was the cheap plastic pedals. but NO. if I just hold the 2 cranks I can reproduct the click sounds and I can feel some play. I tried to remove the cranks, clean/greases but torque it...

After my first puncture, i just changed my inner tubes with ones that have slime in it. 2000km latter, havent had a single puncture. Could be just luck Its even heavier now than before.. probably +200g.

it should be. ours was way out of warranty and not worth the repair.

my gf had a gazelle cityzen with a bosh motor which was doing something similar. it was the motor, think there is a cluch in it which after a while it start slipping. it feels like when u have a worn chain/cassette but in this case the slipping come from the motor. so the chain wont move. just...

i did order some bits and bobs, but never received them... they screwed up my address in it's stuck with DHL for a week now they dispatched it quick, like next day... not sure who to blame. only spend 10 eur so cannot be bother to call DHL at this point

maintenance it's part of the fun - other than electronics i do it myself.